[v2] staging: rtl8192e: Remove whitespace and blank lines
Commit Message
This patch cleans up extraneous whitespace for the
struct rt_hi_throughput definition.
Signed-off-by: Tree Davies <tdavies@darkphysics.net>
---
v2: Fix subject line and send patch inline.
drivers/staging/rtl8192e/rtl819x_HT.h | 63 ++++++++++-----------------
1 file changed, 23 insertions(+), 40 deletions(-)
Comments
On Tue, Jun 20, 2023 at 07:43:52PM -0700, Tree Davies wrote:
> This patch cleans up extraneous whitespace for the
> struct rt_hi_throughput definition.
>
> Signed-off-by: Tree Davies <tdavies@darkphysics.net>
> ---
> v2: Fix subject line and send patch inline.
> drivers/staging/rtl8192e/rtl819x_HT.h | 63 ++++++++++-----------------
> 1 file changed, 23 insertions(+), 40 deletions(-)
>
> diff --git a/drivers/staging/rtl8192e/rtl819x_HT.h b/drivers/staging/rtl8192e/rtl819x_HT.h
> index f4e9fa849796..f5ab19694f1a 100644
> --- a/drivers/staging/rtl8192e/rtl819x_HT.h
> +++ b/drivers/staging/rtl8192e/rtl819x_HT.h
> @@ -96,70 +96,53 @@ enum ht_aggre_mode {
>
>
> struct rt_hi_throughput {
> - u8 enable_ht;
> - u8 bCurrentHTSupport;
> -
> - u8 bRegBW40MHz;
> - u8 bCurBW40MHz;
> -
> - u8 bRegShortGI40MHz;
> - u8 bCurShortGI40MHz;
> -
> - u8 bRegShortGI20MHz;
> - u8 bCurShortGI20MHz;
> -
> - u8 bRegSuppCCK;
> - u8 bCurSuppCCK;
> -
> + u8 enable_ht;
> + u8 bCurrentHTSupport;
> + u8 bRegBW40MHz;
> + u8 bCurBW40MHz;
> + u8 bRegShortGI40MHz;
> + u8 bCurShortGI40MHz;
> + u8 bRegShortGI20MHz;
> + u8 bCurShortGI20MHz;
> + u8 bRegSuppCCK;
> + u8 bCurSuppCCK;
> enum ht_spec_ver ePeerHTSpecVer;
> -
> -
> struct ht_capab_ele SelfHTCap;
> struct ht_info_ele SelfHTInfo;
> -
> - u8 PeerHTCapBuf[32];
> - u8 PeerHTInfoBuf[32];
> -
> -
> - u8 bAMSDU_Support;
> - u16 nAMSDU_MaxSize;
> - u8 bCurrent_AMSDU_Support;
> - u16 nCurrent_AMSDU_MaxSize;
> -
> - u8 bAMPDUEnable;
> - u8 bCurrentAMPDUEnable;
> - u8 AMPDU_Factor;
> - u8 CurrentAMPDUFactor;
> - u8 MPDU_Density;
> + u8 PeerHTCapBuf[32];
> + u8 PeerHTInfoBuf[32];
> + u8 bAMSDU_Support;
> + u16 nAMSDU_MaxSize;
> + u8 bCurrent_AMSDU_Support;
> + u16 nCurrent_AMSDU_MaxSize;
> + u8 bAMPDUEnable;
> + u8 bCurrentAMPDUEnable;
> + u8 AMPDU_Factor;
> + u8 CurrentAMPDUFactor;
> + u8 MPDU_Density;
> u8 current_mpdu_density;
> -
> enum ht_aggre_mode ForcedAMPDUMode;
> u8 forced_ampdu_factor;
> u8 forced_mpdu_density;
> -
> enum ht_aggre_mode ForcedAMSDUMode;
> u8 forced_short_gi;
> -
> u8 current_op_mode;
> -
> u8 self_mimo_ps;
> u8 peer_mimo_ps;
> -
> enum ht_extchnl_offset CurSTAExtChnlOffset;
> u8 cur_tx_bw40mhz;
> u8 sw_bw_in_progress;
> u8 reg_rt2rt_aggregation;
> - u8 RT2RT_HT_Mode;
> + u8 RT2RT_HT_Mode;
> u8 current_rt2rt_aggregation;
> u8 current_rt2rt_long_slot_time;
> u8 sz_rt2rt_agg_buf[10];
> -
> u8 reg_rx_reorder_enable;
> u8 cur_rx_reorder_enable;
> u8 rx_reorder_win_size;
> u8 rx_reorder_pending_time;
> u16 rx_reorder_drop_counter;
> - u8 IOTPeer;
> + u8 IOTPeer;
> u32 iot_action;
> u8 iot_ra_func;
> } __packed;
> --
> 2.39.2
>
Hi,
This is the friendly patch-bot of Greg Kroah-Hartman. You have sent him
a patch that has triggered this response. He used to manually respond
to these common problems, but in order to save his sanity (he kept
writing the same thing over and over, yet to different people), I was
created. Hopefully you will not take offence and will fix the problem
in your patch and resubmit it so that it can be accepted into the Linux
kernel tree.
You are receiving this message because of the following common error(s)
as indicated below:
- Your patch did not apply to any known trees that Greg is in control
of. Possibly this is because you made it against Linus's tree, not
the linux-next tree, which is where all of the development for the
next version of the kernel is at. Please refresh your patch against
the linux-next tree, or even better yet, the development tree
specified in the MAINTAINERS file for the subsystem you are submitting
a patch for, and resend it.
If you wish to discuss this problem further, or you have questions about
how to resolve this issue, please feel free to respond to this email and
Greg will reply once he has dug out from the pending patches received
from other developers.
thanks,
greg k-h's patch email bot
@@ -96,70 +96,53 @@ enum ht_aggre_mode {
struct rt_hi_throughput {
- u8 enable_ht;
- u8 bCurrentHTSupport;
-
- u8 bRegBW40MHz;
- u8 bCurBW40MHz;
-
- u8 bRegShortGI40MHz;
- u8 bCurShortGI40MHz;
-
- u8 bRegShortGI20MHz;
- u8 bCurShortGI20MHz;
-
- u8 bRegSuppCCK;
- u8 bCurSuppCCK;
-
+ u8 enable_ht;
+ u8 bCurrentHTSupport;
+ u8 bRegBW40MHz;
+ u8 bCurBW40MHz;
+ u8 bRegShortGI40MHz;
+ u8 bCurShortGI40MHz;
+ u8 bRegShortGI20MHz;
+ u8 bCurShortGI20MHz;
+ u8 bRegSuppCCK;
+ u8 bCurSuppCCK;
enum ht_spec_ver ePeerHTSpecVer;
-
-
struct ht_capab_ele SelfHTCap;
struct ht_info_ele SelfHTInfo;
-
- u8 PeerHTCapBuf[32];
- u8 PeerHTInfoBuf[32];
-
-
- u8 bAMSDU_Support;
- u16 nAMSDU_MaxSize;
- u8 bCurrent_AMSDU_Support;
- u16 nCurrent_AMSDU_MaxSize;
-
- u8 bAMPDUEnable;
- u8 bCurrentAMPDUEnable;
- u8 AMPDU_Factor;
- u8 CurrentAMPDUFactor;
- u8 MPDU_Density;
+ u8 PeerHTCapBuf[32];
+ u8 PeerHTInfoBuf[32];
+ u8 bAMSDU_Support;
+ u16 nAMSDU_MaxSize;
+ u8 bCurrent_AMSDU_Support;
+ u16 nCurrent_AMSDU_MaxSize;
+ u8 bAMPDUEnable;
+ u8 bCurrentAMPDUEnable;
+ u8 AMPDU_Factor;
+ u8 CurrentAMPDUFactor;
+ u8 MPDU_Density;
u8 current_mpdu_density;
-
enum ht_aggre_mode ForcedAMPDUMode;
u8 forced_ampdu_factor;
u8 forced_mpdu_density;
-
enum ht_aggre_mode ForcedAMSDUMode;
u8 forced_short_gi;
-
u8 current_op_mode;
-
u8 self_mimo_ps;
u8 peer_mimo_ps;
-
enum ht_extchnl_offset CurSTAExtChnlOffset;
u8 cur_tx_bw40mhz;
u8 sw_bw_in_progress;
u8 reg_rt2rt_aggregation;
- u8 RT2RT_HT_Mode;
+ u8 RT2RT_HT_Mode;
u8 current_rt2rt_aggregation;
u8 current_rt2rt_long_slot_time;
u8 sz_rt2rt_agg_buf[10];
-
u8 reg_rx_reorder_enable;
u8 cur_rx_reorder_enable;
u8 rx_reorder_win_size;
u8 rx_reorder_pending_time;
u16 rx_reorder_drop_counter;
- u8 IOTPeer;
+ u8 IOTPeer;
u32 iot_action;
u8 iot_ra_func;
} __packed;