[RFC,net-next,v3,13/15] net: dsa: mt7530: add support for 10G link modes for CPU port
Commit Message
The built-in switch of the MT7988 SoC is internally connected using
a stateless 10G link. Add support for 10G interface modes to silence
a warning otherwise occurring when the switch driver is setup.
Signed-off-by: Daniel Golle <daniel@makrotopia.org>
---
drivers/net/dsa/mt7530.c | 7 ++++++-
1 file changed, 6 insertions(+), 1 deletion(-)
Comments
On Wed, Mar 29, 2023 at 05:00:21PM +0100, Daniel Golle wrote:
> The built-in switch of the MT7988 SoC is internally connected using
> a stateless 10G link. Add support for 10G interface modes to silence
> a warning otherwise occurring when the switch driver is setup.
>
> Signed-off-by: Daniel Golle <daniel@makrotopia.org>
Reviewed-by: Andrew Lunn <andrew@lunn.ch>
Andrew
@@ -2616,6 +2616,9 @@ mt7531_mac_config(struct dsa_switch *ds, int port, unsigned int mode,
case PHY_INTERFACE_MODE_1000BASEX:
case PHY_INTERFACE_MODE_2500BASEX:
/* handled in SGMII PCS driver */
+ case PHY_INTERFACE_MODE_USXGMII:
+ case PHY_INTERFACE_MODE_10GKR:
+ /* internal stateless 10G link */
return 0;
default:
return -EINVAL;
@@ -2739,7 +2742,9 @@ static void mt753x_phylink_mac_link_up(struct dsa_switch *ds, int port,
* variants.
*/
if (interface == PHY_INTERFACE_MODE_TRGMII ||
- (phy_interface_mode_is_8023z(interface))) {
+ interface == PHY_INTERFACE_MODE_USXGMII ||
+ interface == PHY_INTERFACE_MODE_10GKR ||
+ phy_interface_mode_is_8023z(interface)) {
speed = SPEED_1000;
duplex = DUPLEX_FULL;
}