[v4,3/4] i2c: octeon: Handle watchdog timeout
Commit Message
From: Suneel Garapati <sgarapati@marvell.com>
Add watchdog timeout handling to cater to the unhandled warnings
seen during validation on boards with different I2C slaves.
This status code reflects the state that controller couldn't
receive any response from slave while being in non-idle state
and HW recommends to reset before any further bus access.
Signed-off-by: Suneel Garapati <sgarapati@marvell.com>
Signed-off-by: Piyush Malgujar <pmalgujar@marvell.com>
Acked-by: Andi Shyti <andi.shyti@kernel.org>
---
drivers/i2c/busses/i2c-octeon-core.c | 8 ++++++++
drivers/i2c/busses/i2c-octeon-core.h | 4 ++++
2 files changed, 12 insertions(+)
@@ -182,6 +182,7 @@ static int octeon_i2c_hlc_wait(struct octeon_i2c *i2c)
static int octeon_i2c_check_status(struct octeon_i2c *i2c, int final_read)
{
u8 stat;
+ u64 mode;
/*
* This is ugly... in HLC mode the status is not in the status register
@@ -244,6 +245,13 @@ static int octeon_i2c_check_status(struct octeon_i2c *i2c, int final_read)
case STAT_RXADDR_NAK:
case STAT_AD2W_NAK:
return -ENXIO;
+
+ case STAT_WDOG_TOUT:
+ mode = __raw_readq(i2c->twsi_base + MODE(i2c));
+ /* Set BUS_MON_RST to reset bus monitor */
+ mode |= BUS_MON_RST_MASK;
+ octeon_i2c_writeq_flush(mode, i2c->twsi_base + MODE(i2c));
+ return -EIO;
default:
dev_err(i2c->dev, "unhandled state: %d\n", stat);
return -EIO;
@@ -72,6 +72,7 @@
#define STAT_SLAVE_ACK 0xC8
#define STAT_AD2W_ACK 0xD0
#define STAT_AD2W_NAK 0xD8
+#define STAT_WDOG_TOUT 0xF0
#define STAT_IDLE 0xF8
/* TWSI_INT values */
@@ -104,6 +105,9 @@ struct octeon_i2c_reg_offset {
/* Set REFCLK_SRC and HS_MODE in TWSX_MODE register */
#define TWSX_MODE_HS_MASK (BIT(4) | BIT(0))
+/* Set BUS_MON_RST to reset bus monitor */
+#define BUS_MON_RST_MASK BIT(3)
+
struct octeon_i2c {
wait_queue_head_t queue;
struct i2c_adapter adap;