diff mbox series

[RFC,20/21] SQUASH: media: ti: j721e-csi2rx: Assert pixel reset before stopping last stream

Message ID 20240222-multistream-v1-20-1837ed916eeb@ti.com
State New
Headers
Series media: cadence,ti: CSI2RX Multistream Support |

Commit Message

Jai Luthra Feb. 22, 2024, 11:31 a.m. UTC 
  With multi-stream support, make sure pixel reset is only asserted when
last-stream is stopped.

We assert this before stopping the stream to prevent issues with module
unload/reload. As the device's power domain cannot be cleanly switched
off by the firmware if stale data is present on the PSI-L endpoint,
which can happen if source was streaming but we pulling data out through
DMA.

Signed-off-by: Jai Luthra <j-luthra@ti.com>
---
 drivers/media/platform/ti/j721e-csi2rx/j721e-csi2rx.c | 12 ++++++++----
 1 file changed, 8 insertions(+), 4 deletions(-)
diff mbox series

Patch

diff --git a/drivers/media/platform/ti/j721e-csi2rx/j721e-csi2rx.c b/drivers/media/platform/ti/j721e-csi2rx/j721e-csi2rx.c
index c2d47507b3a7..0b9e0852da9f 100644
--- a/drivers/media/platform/ti/j721e-csi2rx/j721e-csi2rx.c
+++ b/drivers/media/platform/ti/j721e-csi2rx/j721e-csi2rx.c
@@ -560,8 +560,10 @@  static void ti_csi2rx_setup_shim(struct ti_csi2rx_ctx *ctx)
 	fmt = find_format_by_fourcc(ctx->v_fmt.fmt.pix.pixelformat);
 
 	/* De-assert the pixel interface reset. */
-	reg = SHIM_CNTL_PIX_RST;
-	writel(reg, csi->shim + SHIM_CNTL);
+	if (!csi->enable_count) {
+		reg = SHIM_CNTL_PIX_RST;
+		writel(reg, csi->shim + SHIM_CNTL);
+	}
 
 	reg = SHIM_DMACNTX_EN;
 	reg |= FIELD_PREP(SHIM_DMACNTX_FMT, fmt->csi_dt);
@@ -1008,9 +1010,11 @@  static void ti_csi2rx_stop_streaming(struct vb2_queue *vq)
 	struct ti_csi2rx_dev *csi = ctx->csi;
 	int ret;
 
-	video_device_pipeline_stop(&ctx->vdev);
+	/* assert pixel reset to prevent stale data on stopping last stream */
+	if (csi->enable_count == 1)
+		writel(0, csi->shim + SHIM_CNTL);
 
-	writel(0, csi->shim + SHIM_CNTL);
+	video_device_pipeline_stop(&ctx->vdev);
 	writel(0, csi->shim + SHIM_DMACNTX(ctx->idx));
 
 	ret = v4l2_subdev_disable_streams(&csi->subdev,