soc: qcom: spm: fix building with CONFIG_REGULATOR=n
Commit Message
From: Arnd Bergmann <arnd@arndb.de>
The newly added code causes a build failure when -Werror is set:
drivers/soc/qcom/spm.c:388:12: error: 'spm_get_cpu' defined but not used [-Werror=unused-function]
Remove the #ifdef and instead use an IS_ENABLED() check that lets the
compiler perform dead code elimination instead of the preprocessor.
Fixes: 6496dba142f4 ("soc: qcom: spm: add support for voltage regulator")
Signed-off-by: Arnd Bergmann <arnd@arndb.de>
---
drivers/soc/qcom/spm.c | 12 ++++--------
1 file changed, 4 insertions(+), 8 deletions(-)
@@ -411,7 +411,6 @@ static int spm_get_cpu(struct device *dev)
return -EOPNOTSUPP;
}
-#ifdef CONFIG_REGULATOR
static int spm_register_regulator(struct device *dev, struct spm_driver_data *drv)
{
struct regulator_config config = {
@@ -474,12 +473,6 @@ static int spm_register_regulator(struct device *dev, struct spm_driver_data *dr
return 0;
}
-#else
-static int spm_register_regulator(struct device *dev, struct spm_driver_data *drv)
-{
- return 0;
-}
-#endif
static const struct of_device_id spm_match_table[] = {
{ .compatible = "qcom,sdm660-gold-saw2-v4.1-l2",
@@ -559,7 +552,10 @@ static int spm_dev_probe(struct platform_device *pdev)
if (drv->reg_data->reg_offset[SPM_REG_SPM_CTL])
spm_set_low_power_mode(drv, PM_SLEEP_MODE_STBY);
- return spm_register_regulator(&pdev->dev, drv);
+ if (IS_ENABLED(CONFIG_REGULATOR))
+ return spm_register_regulator(&pdev->dev, drv);
+
+ return 0;
}
static struct platform_driver spm_driver = {