[v2,2/2] iio: temperature: tmp117: add support for vcc-supply
Commit Message
From: Thomas Haemmerle <thomas.haemmerle@leica-geosystems.com>
Add support to specify the VCC supply which is required to power the
device. According the datasheet 7.3.1 Power Up, the device needs 1.5ms
after the supply voltage reaches the operating range before the
communcation can begin.
Signed-off-by: Thomas Haemmerle <thomas.haemmerle@leica-geosystems.com>
Signed-off-by: Marco Felsch <m.felsch@pengutronix.de>
---
v2:
- add fsleep() after powering the device
drivers/iio/temperature/tmp117.c | 9 +++++++++
1 file changed, 9 insertions(+)
@@ -9,6 +9,7 @@
* Note: This driver assumes that the sensor has been calibrated beforehand.
*/
+#include <linux/delay.h>
#include <linux/err.h>
#include <linux/i2c.h>
#include <linux/module.h>
@@ -17,6 +18,7 @@
#include <linux/kernel.h>
#include <linux/limits.h>
#include <linux/property.h>
+#include <linux/regulator/consumer.h>
#include <linux/iio/iio.h>
@@ -148,10 +150,17 @@ static int tmp117_probe(struct i2c_client *client)
struct tmp117_data *data;
struct iio_dev *indio_dev;
int dev_id;
+ int ret;
if (!i2c_check_functionality(client->adapter, I2C_FUNC_SMBUS_WORD_DATA))
return -EOPNOTSUPP;
+ ret = devm_regulator_get_enable(&client->dev, "vcc");
+ if (ret)
+ return ret;
+
+ fsleep(1500);
+
dev_id = i2c_smbus_read_word_swapped(client, TMP117_REG_DEVICE_ID);
if (dev_id < 0)
return dev_id;