diff mbox series

[v15,23/23] riscv: dts: starfive: add PCIe dts configuration for JH7110

Message ID 20240218101921.113528-8-minda.chen@starfivetech.com
State New
Headers
Series [v15,01/23] dt-bindings: PCI: Add PLDA XpressRICH PCIe host common properties |

Commit Message

Minda Chen Feb. 18, 2024, 10:19 a.m. UTC 
  Add PCIe dts configuraion for JH7110 SoC platform.

Signed-off-by: Minda Chen <minda.chen@starfivetech.com>
Reviewed-by: Hal Feng <hal.feng@starfivetech.com>
---
 .../jh7110-starfive-visionfive-2.dtsi         | 64 ++++++++++++++
 arch/riscv/boot/dts/starfive/jh7110.dtsi      | 86 +++++++++++++++++++
 2 files changed, 150 insertions(+)
diff mbox series

Patch

diff --git a/arch/riscv/boot/dts/starfive/jh7110-starfive-visionfive-2.dtsi b/arch/riscv/boot/dts/starfive/jh7110-starfive-visionfive-2.dtsi
index b89e9791efa7..2f8056d6f817 100644
--- a/arch/riscv/boot/dts/starfive/jh7110-starfive-visionfive-2.dtsi
+++ b/arch/riscv/boot/dts/starfive/jh7110-starfive-visionfive-2.dtsi
@@ -287,6 +287,22 @@ 
 	status = "okay";
 };
 
+&pcie0 {
+	perst-gpios = <&sysgpio 26 GPIO_ACTIVE_LOW>;
+	phys = <&pciephy0>;
+	pinctrl-names = "default";
+	pinctrl-0 = <&pcie0_pins>;
+	status = "okay";
+};
+
+&pcie1 {
+	perst-gpios = <&sysgpio 28 GPIO_ACTIVE_LOW>;
+	phys = <&pciephy1>;
+	pinctrl-names = "default";
+	pinctrl-0 = <&pcie1_pins>;
+	status = "okay";
+};
+
 &qspi {
 	#address-cells = <1>;
 	#size-cells = <0>;
@@ -513,6 +529,54 @@ 
 		};
 	};
 
+	pcie0_pins: pcie0-0 {
+		clkreq-pins {
+			pinmux = <GPIOMUX(27, GPOUT_LOW,
+					      GPOEN_DISABLE,
+					      GPI_NONE)>;
+			bias-pull-down;
+			drive-strength = <2>;
+			input-enable;
+			input-schmitt-disable;
+			slew-rate = <0>;
+		};
+
+		wake-pins {
+			pinmux = <GPIOMUX(32, GPOUT_LOW,
+					      GPOEN_DISABLE,
+					      GPI_NONE)>;
+			bias-pull-up;
+			drive-strength = <2>;
+			input-enable;
+			input-schmitt-disable;
+			slew-rate = <0>;
+		};
+	};
+
+	pcie1_pins: pcie1-0 {
+		clkreq-pins {
+			pinmux = <GPIOMUX(29, GPOUT_LOW,
+					      GPOEN_DISABLE,
+					      GPI_NONE)>;
+			bias-pull-down;
+			drive-strength = <2>;
+			input-enable;
+			input-schmitt-disable;
+			slew-rate = <0>;
+		};
+
+		wake-pins {
+			pinmux = <GPIOMUX(21, GPOUT_LOW,
+					      GPOEN_DISABLE,
+					      GPI_NONE)>;
+			bias-pull-up;
+			drive-strength = <2>;
+			input-enable;
+			input-schmitt-disable;
+			slew-rate = <0>;
+		};
+	};
+
 	spi0_pins: spi0-0 {
 		mosi-pins {
 			pinmux = <GPIOMUX(52, GPOUT_SYS_SPI0_TXD,
diff --git a/arch/riscv/boot/dts/starfive/jh7110.dtsi b/arch/riscv/boot/dts/starfive/jh7110.dtsi
index 45213cdf50dc..dfa2f94ed5b2 100644
--- a/arch/riscv/boot/dts/starfive/jh7110.dtsi
+++ b/arch/riscv/boot/dts/starfive/jh7110.dtsi
@@ -1138,5 +1138,91 @@ 
 			#reset-cells = <1>;
 			power-domains = <&pwrc JH7110_PD_VOUT>;
 		};
+
+		pcie0: pcie@940000000 {
+			compatible = "starfive,jh7110-pcie";
+			reg = <0x9 0x40000000 0x0 0x1000000>,
+			      <0x0 0x2b000000 0x0 0x100000>;
+			reg-names = "cfg", "apb";
+			linux,pci-domain = <0>;
+			#address-cells = <3>;
+			#size-cells = <2>;
+			#interrupt-cells = <1>;
+			ranges = <0x82000000  0x0 0x30000000  0x0 0x30000000 0x0 0x08000000>,
+				 <0xc3000000  0x9 0x00000000  0x9 0x00000000 0x0 0x40000000>;
+			interrupts = <56>;
+			interrupt-map-mask = <0x0 0x0 0x0 0x7>;
+			interrupt-map = <0x0 0x0 0x0 0x1 &pcie_intc0 0x1>,
+					<0x0 0x0 0x0 0x2 &pcie_intc0 0x2>,
+					<0x0 0x0 0x0 0x3 &pcie_intc0 0x3>,
+					<0x0 0x0 0x0 0x4 &pcie_intc0 0x4>;
+			msi-controller;
+			device_type = "pci";
+			starfive,stg-syscon = <&stg_syscon>;
+			bus-range = <0x0 0xff>;
+			clocks = <&syscrg JH7110_SYSCLK_NOC_BUS_STG_AXI>,
+				 <&stgcrg JH7110_STGCLK_PCIE0_TL>,
+				 <&stgcrg JH7110_STGCLK_PCIE0_AXI_MST0>,
+				 <&stgcrg JH7110_STGCLK_PCIE0_APB>;
+			clock-names = "noc", "tl", "axi_mst0", "apb";
+			resets = <&stgcrg JH7110_STGRST_PCIE0_AXI_MST0>,
+				 <&stgcrg JH7110_STGRST_PCIE0_AXI_SLV0>,
+				 <&stgcrg JH7110_STGRST_PCIE0_AXI_SLV>,
+				 <&stgcrg JH7110_STGRST_PCIE0_BRG>,
+				 <&stgcrg JH7110_STGRST_PCIE0_CORE>,
+				 <&stgcrg JH7110_STGRST_PCIE0_APB>;
+			reset-names = "mst0", "slv0", "slv", "brg",
+				      "core", "apb";
+			status = "disabled";
+
+			pcie_intc0: interrupt-controller {
+				#address-cells = <0>;
+				#interrupt-cells = <1>;
+				interrupt-controller;
+			};
+		};
+
+		pcie1: pcie@9c0000000 {
+			compatible = "starfive,jh7110-pcie";
+			reg = <0x9 0xc0000000 0x0 0x1000000>,
+			      <0x0 0x2c000000 0x0 0x100000>;
+			reg-names = "cfg", "apb";
+			linux,pci-domain = <1>;
+			#address-cells = <3>;
+			#size-cells = <2>;
+			#interrupt-cells = <1>;
+			ranges = <0x82000000  0x0 0x38000000  0x0 0x38000000 0x0 0x08000000>,
+				 <0xc3000000  0x9 0x80000000  0x9 0x80000000 0x0 0x40000000>;
+			interrupts = <57>;
+			interrupt-map-mask = <0x0 0x0 0x0 0x7>;
+			interrupt-map = <0x0 0x0 0x0 0x1 &pcie_intc1 0x1>,
+					<0x0 0x0 0x0 0x2 &pcie_intc1 0x2>,
+					<0x0 0x0 0x0 0x3 &pcie_intc1 0x3>,
+					<0x0 0x0 0x0 0x4 &pcie_intc1 0x4>;
+			msi-controller;
+			device_type = "pci";
+			starfive,stg-syscon = <&stg_syscon>;
+			bus-range = <0x0 0xff>;
+			clocks = <&syscrg JH7110_SYSCLK_NOC_BUS_STG_AXI>,
+				 <&stgcrg JH7110_STGCLK_PCIE1_TL>,
+				 <&stgcrg JH7110_STGCLK_PCIE1_AXI_MST0>,
+				 <&stgcrg JH7110_STGCLK_PCIE1_APB>;
+			clock-names = "noc", "tl", "axi_mst0", "apb";
+			resets = <&stgcrg JH7110_STGRST_PCIE1_AXI_MST0>,
+				 <&stgcrg JH7110_STGRST_PCIE1_AXI_SLV0>,
+				 <&stgcrg JH7110_STGRST_PCIE1_AXI_SLV>,
+				 <&stgcrg JH7110_STGRST_PCIE1_BRG>,
+				 <&stgcrg JH7110_STGRST_PCIE1_CORE>,
+				 <&stgcrg JH7110_STGRST_PCIE1_APB>;
+			reset-names = "mst0", "slv0", "slv", "brg",
+				      "core", "apb";
+			status = "disabled";
+
+			pcie_intc1: interrupt-controller {
+				#address-cells = <0>;
+				#interrupt-cells = <1>;
+				interrupt-controller;
+			};
+		};
 	};
 };