[v6,4/5] drm/amd: Fetch the EDID from _DDC if available for eDP
Commit Message
Some manufacturers have intentionally put an EDID that differs from
the EDID on the internal panel on laptops.
Attempt to fetch this EDID if it exists and prefer it over the EDID
that is provided by the panel. If a user prefers to use the EDID from
the panel, offer a module parameter that would disable this.
Signed-off-by: Mario Limonciello <mario.limonciello@amd.com>
---
drivers/gpu/drm/amd/amdgpu/amdgpu.h | 1 +
drivers/gpu/drm/amd/amdgpu/amdgpu_connectors.c | 3 +++
drivers/gpu/drm/amd/amdgpu/amdgpu_drv.c | 8 ++++++++
drivers/gpu/drm/amd/display/amdgpu_dm/amdgpu_dm.c | 4 +++-
drivers/gpu/drm/amd/display/amdgpu_dm/amdgpu_dm_helpers.c | 2 ++
5 files changed, 17 insertions(+), 1 deletion(-)
@@ -215,6 +215,7 @@ extern int amdgpu_smartshift_bias;
extern int amdgpu_use_xgmi_p2p;
extern int amdgpu_mtype_local;
extern bool enforce_isolation;
+extern bool acpi_edid;
#ifdef CONFIG_HSA_AMD
extern int sched_policy;
extern bool debug_evictions;
@@ -281,6 +281,9 @@ static void amdgpu_connector_get_edid(struct drm_connector *connector)
if (amdgpu_connector->edid)
return;
+ /* if the BIOS specifies the EDID via _DDC, prefer this */
+ connector->acpi_edid_allowed = acpi_edid;
+
/* on hw with routers, select right port */
if (amdgpu_connector->router.ddc_valid)
amdgpu_i2c_router_select_ddc_port(amdgpu_connector);
@@ -166,6 +166,7 @@ uint amdgpu_sdma_phase_quantum = 32;
char *amdgpu_disable_cu;
char *amdgpu_virtual_display;
bool enforce_isolation;
+bool acpi_edid = true;
/*
* OverDrive(bit 14) disabled by default
* GFX DCS(bit 19) disabled by default
@@ -990,6 +991,13 @@ MODULE_PARM_DESC(wbrf,
"Enable Wifi RFI interference mitigation (0 = disabled, 1 = enabled, -1 = auto(default)");
module_param_named(wbrf, amdgpu_wbrf, int, 0444);
+/**
+ * DOC: acpi_edid (bool)
+ * Try to fetch EDID for eDP display from BIOS using ACPI _DDC method.
+ */
+module_param(acpi_edid, bool, 0444);
+MODULE_PARM_DESC(acpi_edid, "Fetch EDID for eDP display from BIOS");
+
/* These devices are not supported by amdgpu.
* They are supported by the mach64, r128, radeon drivers
*/
@@ -6649,8 +6649,10 @@ static void amdgpu_dm_connector_funcs_force(struct drm_connector *connector)
* Note: drm_get_edid gets edid in the following order:
* 1) override EDID if set via edid_override debugfs,
* 2) firmware EDID if set via edid_firmware module parameter
- * 3) regular DDC read.
+ * 3) ACPI EDID if allowed via module parameter
+ * 4) regular DDC read.
*/
+ connector->acpi_edid_allowed = acpi_edid;
edid = drm_get_edid(connector, &amdgpu_connector->ddc_bus->aux.ddc);
if (!edid) {
DRM_ERROR("No EDID found on connector: %s.\n", connector->name);
@@ -910,6 +910,8 @@ enum dc_edid_status dm_helpers_read_local_edid(
* do check sum and retry to make sure read correct edid.
*/
do {
+ /* prefer ACPI over panel for eDP */
+ connector->acpi_edid_allowed = acpi_edid;
edid = drm_get_edid(&aconnector->base, ddc);