[RESEND,v2,4/4] arm64: dts: ti: k3-j784s4-evm: Remove Pinmux for CTS and RTS in wkup_uart0

Message ID 20240212104417.1058993-5-b-kapoor@ti.com
State New
Headers
Series arm64: dts: ti: Modify pinmux for wkup_uart0 and mcu_uart0 |

Commit Message

Bhavya Kapoor Feb. 12, 2024, 10:44 a.m. UTC
  Only Tx and Rx Signal lines for wkup_uart0 are brought out on
the J784S4 EVM from SoC, but CTS and RTS signal lines are not
brought on the EVM. Thus, remove pinmux for CTS and RTS signal
lines for wkup_uart0 in J784S4.

Signed-off-by: Bhavya Kapoor <b-kapoor@ti.com>
---
 arch/arm64/boot/dts/ti/k3-j784s4-evm.dts | 2 --
 1 file changed, 2 deletions(-)
  

Patch

diff --git a/arch/arm64/boot/dts/ti/k3-j784s4-evm.dts b/arch/arm64/boot/dts/ti/k3-j784s4-evm.dts
index 57e7cb8ea2b8..9f16642ccd5f 100644
--- a/arch/arm64/boot/dts/ti/k3-j784s4-evm.dts
+++ b/arch/arm64/boot/dts/ti/k3-j784s4-evm.dts
@@ -336,8 +336,6 @@  &wkup_pmx2 {
 	wkup_uart0_pins_default: wkup-uart0-default-pins {
 		bootph-all;
 		pinctrl-single,pins = <
-			J721S2_WKUP_IOPAD(0x070, PIN_INPUT, 0) /* (L37) WKUP_GPIO0_6.WKUP_UART0_CTSn */
-			J721S2_WKUP_IOPAD(0x074, PIN_INPUT, 0) /* (L36) WKUP_GPIO0_7.WKUP_UART0_RTSn */
 			J721S2_WKUP_IOPAD(0x048, PIN_INPUT, 0) /* (K35) WKUP_UART0_RXD */
 			J721S2_WKUP_IOPAD(0x04c, PIN_INPUT, 0) /* (K34) WKUP_UART0_TXD */
 		>;