diff mbox series

[RESEND,v2,3/4] arm64: dts: ti: k3-j721s2-common-proc-board: Remove Pinmux for CTS and RTS in wkup_uart0

Message ID 20240212104417.1058993-4-b-kapoor@ti.com
State New
Headers
Series arm64: dts: ti: Modify pinmux for wkup_uart0 and mcu_uart0 |

Commit Message

Bhavya Kapoor Feb. 12, 2024, 10:44 a.m. UTC 
  Only Tx and Rx Signal lines for wkup_uart0 are brought out on
the Common Proc Board through SoM, but CTS and RTS signal lines
are not brought on the board. Thus, remove pinmux for CTS and RTS
signal lines for wkup_uart0 in J721S2.

Signed-off-by: Bhavya Kapoor <b-kapoor@ti.com>
---
 arch/arm64/boot/dts/ti/k3-j721s2-common-proc-board.dts | 2 --
 1 file changed, 2 deletions(-)
diff mbox series

Patch

diff --git a/arch/arm64/boot/dts/ti/k3-j721s2-common-proc-board.dts b/arch/arm64/boot/dts/ti/k3-j721s2-common-proc-board.dts
index 361365bb5523..6371cb1c1fe7 100644
--- a/arch/arm64/boot/dts/ti/k3-j721s2-common-proc-board.dts
+++ b/arch/arm64/boot/dts/ti/k3-j721s2-common-proc-board.dts
@@ -190,8 +190,6 @@  J721S2_IOPAD(0x038, PIN_OUTPUT, 0) /* (AB28) MCASP0_ACLKX.MCAN5_TX */
 &wkup_pmx2 {
 	wkup_uart0_pins_default: wkup-uart0-default-pins {
 		pinctrl-single,pins = <
-			J721S2_WKUP_IOPAD(0x070, PIN_INPUT, 0) /* (E25) WKUP_GPIO0_6.WKUP_UART0_CTSn */
-			J721S2_WKUP_IOPAD(0x074, PIN_OUTPUT, 0) /* (F28) WKUP_GPIO0_7.WKUP_UART0_RTSn */
 			J721S2_WKUP_IOPAD(0x048, PIN_INPUT, 0) /* (D28) WKUP_UART0_RXD */
 			J721S2_WKUP_IOPAD(0x04c, PIN_OUTPUT, 0) /* (D27) WKUP_UART0_TXD */
 		>;