[3/3] arm64: dts: ti: k3-j784s4-evm: Remove Pinmux for CTS and RTS in Wakeup Uart

Message ID 20240208110602.931573-4-b-kapoor@ti.com
State New
Headers
Series arm64: dts: ti: Modify pinmux for wakeup and mcu uart |

Commit Message

Bhavya Kapoor Feb. 8, 2024, 11:06 a.m. UTC
  Only Tx and Rx Signal lines for wake up uart are brought out on
the J784S4 EVM from SoC, but CTS and RTS signal lines are not
brought on the EVM. Thus, remove pinmux for CTS and RTS signal
lines for wake up uart in J784S4.

Signed-off-by: Bhavya Kapoor <b-kapoor@ti.com>
---
 arch/arm64/boot/dts/ti/k3-j784s4-evm.dts | 2 --
 1 file changed, 2 deletions(-)
  

Patch

diff --git a/arch/arm64/boot/dts/ti/k3-j784s4-evm.dts b/arch/arm64/boot/dts/ti/k3-j784s4-evm.dts
index 57e7cb8ea2b8..9f16642ccd5f 100644
--- a/arch/arm64/boot/dts/ti/k3-j784s4-evm.dts
+++ b/arch/arm64/boot/dts/ti/k3-j784s4-evm.dts
@@ -336,8 +336,6 @@  &wkup_pmx2 {
 	wkup_uart0_pins_default: wkup-uart0-default-pins {
 		bootph-all;
 		pinctrl-single,pins = <
-			J721S2_WKUP_IOPAD(0x070, PIN_INPUT, 0) /* (L37) WKUP_GPIO0_6.WKUP_UART0_CTSn */
-			J721S2_WKUP_IOPAD(0x074, PIN_INPUT, 0) /* (L36) WKUP_GPIO0_7.WKUP_UART0_RTSn */
 			J721S2_WKUP_IOPAD(0x048, PIN_INPUT, 0) /* (K35) WKUP_UART0_RXD */
 			J721S2_WKUP_IOPAD(0x04c, PIN_INPUT, 0) /* (K34) WKUP_UART0_TXD */
 		>;