[net-next,v3,03/17] net: pse-pd: Rectify and adapt the naming of admin_cotrol member of struct pse_control_config
Commit Message
In commit 18ff0bcda6d1 ("ethtool: add interface to interact with Ethernet
Power Equipment"), the 'pse_control_config' structure was introduced,
housing a single member labeled 'admin_cotrol' responsible for maintaining
the operational state of the PoDL PSE functions.
A noticeable typographical error exists in the naming of this field
('cotrol' should be corrected to 'control'), which this commit aims to
rectify.
Furthermore, with upcoming extensions of this structure to encompass PoE
functionalities, the field is being renamed to 'podl_admin_state' to
distinctly indicate that this state is tailored specifically for PoDL."
Sponsored-by: Dent Project <dentproject@linuxfoundation.org>
Reviewed-by: Oleksij Rempel <o.rempel@pengutronix.de>
Reviewed-by: Andrew Lunn <andrew@lunn.ch>
Signed-off-by: Kory Maincent <kory.maincent@bootlin.com>
---
drivers/net/pse-pd/pse_regulator.c | 8 ++++----
include/linux/pse-pd/pse.h | 4 ++--
net/ethtool/pse-pd.c | 2 +-
3 files changed, 7 insertions(+), 7 deletions(-)
@@ -31,10 +31,10 @@ pse_reg_ethtool_set_config(struct pse_controller_dev *pcdev, unsigned long id,
struct pse_reg_priv *priv = to_pse_reg(pcdev);
int ret;
- if (priv->admin_state == config->admin_cotrol)
+ if (priv->admin_state == config->podl_admin_control)
return 0;
- switch (config->admin_cotrol) {
+ switch (config->podl_admin_control) {
case ETHTOOL_PODL_PSE_ADMIN_STATE_ENABLED:
ret = regulator_enable(priv->ps);
break;
@@ -43,14 +43,14 @@ pse_reg_ethtool_set_config(struct pse_controller_dev *pcdev, unsigned long id,
break;
default:
dev_err(pcdev->dev, "Unknown admin state %i\n",
- config->admin_cotrol);
+ config->podl_admin_control);
ret = -ENOTSUPP;
}
if (ret)
return ret;
- priv->admin_state = config->admin_cotrol;
+ priv->admin_state = config->podl_admin_control;
return 0;
}
@@ -15,11 +15,11 @@ struct pse_controller_dev;
/**
* struct pse_control_config - PSE control/channel configuration.
*
- * @admin_cotrol: set PoDL PSE admin control as described in
+ * @podl_admin_control: set PoDL PSE admin control as described in
* IEEE 802.3-2018 30.15.1.2.1 acPoDLPSEAdminControl
*/
struct pse_control_config {
- enum ethtool_podl_pse_admin_state admin_cotrol;
+ enum ethtool_podl_pse_admin_state podl_admin_control;
};
/**
@@ -130,7 +130,7 @@ ethnl_set_pse(struct ethnl_req_info *req_info, struct genl_info *info)
struct phy_device *phydev;
/* this values are already validated by the ethnl_pse_set_policy */
- config.admin_cotrol = nla_get_u32(tb[ETHTOOL_A_PODL_PSE_ADMIN_CONTROL]);
+ config.podl_admin_control = nla_get_u32(tb[ETHTOOL_A_PODL_PSE_ADMIN_CONTROL]);
phydev = dev->phydev;
if (!phydev) {