[v2] KVM: selftests: Compare wall time from xen shinfo against KVM_GET_CLOCK
Commit Message
xen_shinfo_test is observed to be flaky failing sporadically with
"VM time too old". With min_ts/max_ts debug print added:
Wall clock (v 3269818) 1704906491.986255664
Time info 1: v 1282712 tsc 33530585736 time 14014430025 mul 3587552223 shift 4294967295 flags 1
Time info 2: v 1282712 tsc 33530585736 time 14014430025 mul 3587552223 shift 4294967295 flags 1
min_ts: 1704906491.986312153
max_ts: 1704906506.001006963
==== Test Assertion Failure ====
x86_64/xen_shinfo_test.c:1003: cmp_timespec(&min_ts, &vm_ts) <= 0
pid=32724 tid=32724 errno=4 - Interrupted system call
1 0x00000000004030ad: main at xen_shinfo_test.c:1003
2 0x00007fca6b23feaf: ?? ??:0
3 0x00007fca6b23ff5f: ?? ??:0
4 0x0000000000405e04: _start at ??:?
VM time too old
The test compares wall clock data from shinfo (which is the output of
kvm_get_wall_clock_epoch()) against clock_gettime(CLOCK_REALTIME) in the
host system before the VM is created. In the example above, it compares
shinfo: 1704906491.986255664 vs min_ts: 1704906491.986312153
and fails as the later is greater than the former. While this sounds like
a sane test, it doesn't pass reality check: kvm_get_wall_clock_epoch()
calculates guest's epoch (realtime when the guest was created) by
subtracting kvmclock from the current realtime and the calculation happens
when shinfo is setup. The problem is that kvmclock is a raw clock and
realtime clock is affected by NTP. This means that if realtime ticks with a
slightly reduced frequency, "guest's epoch" calculated by
kvm_get_wall_clock_epoch() will actually tick backwards! This is not a big
issue from guest's perspective as the guest can't really observe this but
this epoch can't be compared with a fixed clock_gettime() on the host.
Replace the check with comparing wall clock data from shinfo to
KVM_GET_CLOCK. The later gives both realtime and kvmclock so guest's epoch
can be calculated by subtraction. Note, CLOCK_REALTIME is susceptible to
leap seconds jumps but there's no better alternative in KVM at this
moment. Leave a comment and accept 1s delta.
Reported-by: Jan Richter <jarichte@redhat.com>
Signed-off-by: Vitaly Kuznetsov <vkuznets@redhat.com>
---
Changes since v1 [David Woodhouse]:
- Check for KVM_CLOCK_REALTIME and skip testing shinfo epoch sanity in case
it's missing (e.g. when a non-TSC clocksource is used)
- Add a comment about a potential jump of CLOCK_REALTIME because of a leap
second injection and accept 1s delta. While this is very unlikely anyone
will even hit this in testing, this mostly serves a documentation purpose.
---
.../selftests/kvm/x86_64/xen_shinfo_test.c | 50 +++++++++++--------
1 file changed, 28 insertions(+), 22 deletions(-)
@@ -375,20 +375,6 @@ static void guest_code(void)
GUEST_SYNC(TEST_DONE);
}
-static int cmp_timespec(struct timespec *a, struct timespec *b)
-{
- if (a->tv_sec > b->tv_sec)
- return 1;
- else if (a->tv_sec < b->tv_sec)
- return -1;
- else if (a->tv_nsec > b->tv_nsec)
- return 1;
- else if (a->tv_nsec < b->tv_nsec)
- return -1;
- else
- return 0;
-}
-
static struct vcpu_info *vinfo;
static struct kvm_vcpu *vcpu;
@@ -425,7 +411,6 @@ static void *juggle_shinfo_state(void *arg)
int main(int argc, char *argv[])
{
- struct timespec min_ts, max_ts, vm_ts;
struct kvm_xen_hvm_attr evt_reset;
struct kvm_vm *vm;
pthread_t thread;
@@ -443,8 +428,6 @@ int main(int argc, char *argv[])
bool do_eventfd_tests = !!(xen_caps & KVM_XEN_HVM_CONFIG_EVTCHN_2LEVEL);
bool do_evtchn_tests = do_eventfd_tests && !!(xen_caps & KVM_XEN_HVM_CONFIG_EVTCHN_SEND);
- clock_gettime(CLOCK_REALTIME, &min_ts);
-
vm = vm_create_with_one_vcpu(&vcpu, guest_code);
/* Map a region for the shared_info page */
@@ -969,7 +952,6 @@ int main(int argc, char *argv[])
vm_ioctl(vm, KVM_XEN_HVM_SET_ATTR, &evt_reset);
alarm(0);
- clock_gettime(CLOCK_REALTIME, &max_ts);
/*
* Just a *really* basic check that things are being put in the
@@ -978,6 +960,8 @@ int main(int argc, char *argv[])
*/
struct pvclock_wall_clock *wc;
struct pvclock_vcpu_time_info *ti, *ti2;
+ struct kvm_clock_data kcdata;
+ long long delta;
wc = addr_gpa2hva(vm, SHINFO_REGION_GPA + 0xc00);
ti = addr_gpa2hva(vm, SHINFO_REGION_GPA + 0x40 + 0x20);
@@ -993,12 +977,34 @@ int main(int argc, char *argv[])
ti2->tsc_shift, ti2->flags);
}
- vm_ts.tv_sec = wc->sec;
- vm_ts.tv_nsec = wc->nsec;
TEST_ASSERT(wc->version && !(wc->version & 1),
"Bad wallclock version %x", wc->version);
- TEST_ASSERT(cmp_timespec(&min_ts, &vm_ts) <= 0, "VM time too old");
- TEST_ASSERT(cmp_timespec(&max_ts, &vm_ts) >= 0, "VM time too new");
+
+ vm_ioctl(vm, KVM_GET_CLOCK, &kcdata);
+
+ if (kcdata.flags & KVM_CLOCK_REALTIME) {
+ if (verbose) {
+ printf("KVM_GET_CLOCK clock: %lld.%09lld\n",
+ kcdata.clock / NSEC_PER_SEC, kcdata.clock % NSEC_PER_SEC);
+ printf("KVM_GET_CLOCK realtime: %lld.%09lld\n",
+ kcdata.realtime / NSEC_PER_SEC, kcdata.realtime % NSEC_PER_SEC);
+ }
+
+ delta = (wc->sec * NSEC_PER_SEC + wc->nsec) - (kcdata.realtime - kcdata.clock);
+
+ /*
+ * KVM_GET_CLOCK gives CLOCK_REALTIME which jumps on leap seconds updates but
+ * unfortunately KVM doesn't currently offer a CLOCK_TAI alternative. Accept 1s
+ * delta as testing clock accuracy is not the goal here. The test just needs to
+ * check that the value in shinfo is somewhat sane.
+ */
+ TEST_ASSERT(llabs(delta) < NSEC_PER_SEC,
+ "Guest's epoch from shinfo %d.%09d differs from KVM_GET_CLOCK %lld.%lld",
+ wc->sec, wc->nsec, (kcdata.realtime - kcdata.clock) / NSEC_PER_SEC,
+ (kcdata.realtime - kcdata.clock) % NSEC_PER_SEC);
+ } else {
+ pr_info("Missing KVM_CLOCK_REALTIME, skipping shinfo epoch sanity check\n");
+ }
TEST_ASSERT(ti->version && !(ti->version & 1),
"Bad time_info version %x", ti->version);