diff mbox series

[net-next,2/2] net: phy: qcom: qca808x: default to LED active High if not set

Message ID 20240201134602.11085-3-ansuelsmth@gmail.com
State New
Headers
Series net: phy: qcom: qca808x: fixup qca808x LED |

Commit Message

Christian Marangi Feb. 1, 2024, 1:46 p.m. UTC 
  qca808x PHY provide support for the led_polarity_set OP to configure
and apply the active-low property but on PHY reset, the Active High bit
is not set resulting in the LED driven as active-low.

To fix this, check if active-low is not set in DT and enable Active High
polarity by default to restore correct funcionality of the LED.

Fixes: 7196062b64ee ("net: phy: at803x: add LED support for qca808x")
Signed-off-by: Christian Marangi <ansuelsmth@gmail.com>
---
 drivers/net/phy/qcom/qca808x.c | 10 ++++++++++
 1 file changed, 10 insertions(+)
diff mbox series

Patch

diff --git a/drivers/net/phy/qcom/qca808x.c b/drivers/net/phy/qcom/qca808x.c
index 00db4b274264..d88e04278fc4 100644
--- a/drivers/net/phy/qcom/qca808x.c
+++ b/drivers/net/phy/qcom/qca808x.c
@@ -290,8 +290,18 @@  static int qca808x_probe(struct phy_device *phydev)
 
 static int qca808x_config_init(struct phy_device *phydev)
 {
+	struct qca808x_priv *priv = phydev->priv;
 	int ret;
 
+	/* Default to LED Active High if active-low not in DT */
+	if (priv->led_polarity_mode == -1) {
+		ret = phy_set_bits_mmd(phydev, MDIO_MMD_AN,
+				       QCA808X_MMD7_LED_POLARITY_CTRL,
+				       QCA808X_LED_ACTIVE_HIGH);
+		if (ret)
+			return ret;
+	}
+
 	/* Active adc&vga on 802.3az for the link 1000M and 100M */
 	ret = phy_modify_mmd(phydev, MDIO_MMD_PCS, QCA808X_PHY_MMD3_ADDR_CLD_CTRL7,
 			     QCA808X_8023AZ_AFE_CTRL_MASK, QCA808X_8023AZ_AFE_EN);