diff mbox series

[v4,5/6] arm64: dts: rockchip: rk3399-puma-haikou: add rs485 support on uart2

Message ID 20240126-dev-rx-enable-v4-5-45aaf4d96328@theobroma-systems.com
State New
Headers
Series serial: 8250: Add support for rs485 half/full duplex on puma/ringneck-haikou |

Commit Message

Farouk Bouabid Jan. 26, 2024, 2:55 p.m. UTC 
  A hardware switch can set the rs485 transceiver into half or full duplex
mode.

Switching to the half-duplex mode requires the user to enable em485 on
uart2 using ioctl, DE/RE are both connected to GPIO2_C3 which is the
RTS signal for uart0. Which means GPIO2_C3 is implemented as rs485
rx-enable gpio.

In full-duplex mode (em485 is disabled), DE is connected to GPIO2_C3 and
RE is grounded (enabled). This requires rx-enable gpio to be inactive to
enable DE as well.

Signed-off-by: Farouk Bouabid <farouk.bouabid@theobroma-systems.com>
---
 arch/arm64/boot/dts/rockchip/rk3399-puma-haikou.dts | 4 +++-
 1 file changed, 3 insertions(+), 1 deletion(-)
diff mbox series

Patch

diff --git a/arch/arm64/boot/dts/rockchip/rk3399-puma-haikou.dts b/arch/arm64/boot/dts/rockchip/rk3399-puma-haikou.dts
index 18a98c4648ea..576024c745ed 100644
--- a/arch/arm64/boot/dts/rockchip/rk3399-puma-haikou.dts
+++ b/arch/arm64/boot/dts/rockchip/rk3399-puma-haikou.dts
@@ -273,11 +273,13 @@  &u2phy0_host {
 
 &uart0 {
 	pinctrl-names = "default";
-	pinctrl-0 = <&uart0_xfer &uart0_cts &uart0_rts>;
+	pinctrl-0 = <&uart0_xfer>;
 	status = "okay";
 };
 
 &uart2 {
+	rs485-rx-enable-gpios = <&gpio2 RK_PC3 GPIO_ACTIVE_LOW>;
+	rs485-rx-enable-inactive-when-rs485-disabled;
 	status = "okay";
 };