[v3,1/3] LoongArch: KVM: Remove SW timer switch when vcpu is halt polling
Commit Message
With halt-polling supported, there is checking for pending events
or interrupts when vcpu executes idle instruction. Pending interrupts
include injected SW interrupts and passthrough HW interrupts, such as
HW timer interrupts, since HW timer works still even if vcpu exists
from VM mode.
Since HW timer pending interrupt can be set directly with CSR status
register, and pending HW timer interrupt checking is used in vcpu block
checking function, it is not necessary to switch to sw timer during
halt-polling. This patch adds preemption disabling in function
kvm_cpu_has_pending_timer, and removes SW timer switching in idle
instruction emulation function.
Signed-off-by: Bibo Mao <maobibo@loongson.cn>
---
arch/loongarch/kvm/exit.c | 13 ++-----------
arch/loongarch/kvm/vcpu.c | 9 ++++++++-
2 files changed, 10 insertions(+), 12 deletions(-)
@@ -200,17 +200,8 @@ int kvm_emu_idle(struct kvm_vcpu *vcpu)
++vcpu->stat.idle_exits;
trace_kvm_exit_idle(vcpu, KVM_TRACE_EXIT_IDLE);
- if (!kvm_arch_vcpu_runnable(vcpu)) {
- /*
- * Switch to the software timer before halt-polling/blocking as
- * the guest's timer may be a break event for the vCPU, and the
- * hypervisor timer runs only when the CPU is in guest mode.
- * Switch before halt-polling so that KVM recognizes an expired
- * timer before blocking.
- */
- kvm_save_timer(vcpu);
- kvm_vcpu_block(vcpu);
- }
+ if (!kvm_arch_vcpu_runnable(vcpu))
+ kvm_vcpu_halt(vcpu);
return EMULATE_DONE;
}
@@ -187,8 +187,15 @@ int kvm_arch_vcpu_ioctl_translate(struct kvm_vcpu *vcpu,
int kvm_cpu_has_pending_timer(struct kvm_vcpu *vcpu)
{
- return kvm_pending_timer(vcpu) ||
+ int ret;
+
+ /* protect from TOD sync and vcpu_load/put */
+ preempt_disable();
+ ret = kvm_pending_timer(vcpu) ||
kvm_read_hw_gcsr(LOONGARCH_CSR_ESTAT) & (1 << INT_TI);
+ preempt_enable();
+
+ return ret;
}
int kvm_arch_vcpu_dump_regs(struct kvm_vcpu *vcpu)