[v1,1/2] PCI: xilinx-nwl: Update ECAM default value and remove unnecessary code.
Commit Message
Our controller is expecting ECAM size to be programmed by software.
By programming "NWL_ECAM_VALUE_DEFAULT 12" controller can access up to
16MB ECAM region which is used to detect 16 buses, so by updating
"NWL_ECAM_VALUE_DEFAULT " to 16 so that controller can access up to 256MB
ECAM region to detect 256 buses.
E_ECAM_CONTROL register from bit 16 to 20 uses this value as input
to calculate ECAM Size.
The primary,secondary and sub-ordinate bus number registers are updated
by Linux PCI core, so removing code which is updating primary,secondary
and sub-ordinate bus numbers of type 1 header 18th offset of ECAM.
Signed-off-by: Thippeswamy Havalige <thippeswamy.havalige@amd.com>
Signed-off-by: Bharat Kumar Gogada <bharat.kumar.gogada@amd.com>
---
| Reported-by: kernel test robot <lkp@intel.com>
| Closes:
| https://lore.kernel.org/oe-kbuild-all/202308040330.eMTjX3tF-lkp@intel.
| com/
---
drivers/pci/controller/pcie-xilinx-nwl.c | 18 +++---------------
1 file changed, 3 insertions(+), 15 deletions(-)
@@ -126,7 +126,7 @@
#define E_ECAM_CR_ENABLE BIT(0)
#define E_ECAM_SIZE_LOC GENMASK(20, 16)
#define E_ECAM_SIZE_SHIFT 16
-#define NWL_ECAM_VALUE_DEFAULT 12
+#define NWL_ECAM_VALUE_DEFAULT 16
#define CFG_DMA_REG_BAR GENMASK(2, 0)
#define CFG_PCIE_CACHE GENMASK(7, 0)
@@ -165,8 +165,6 @@ struct nwl_pcie {
u32 ecam_size;
int irq_intx;
int irq_misc;
- u32 ecam_value;
- u8 last_busno;
struct nwl_msi msi;
struct irq_domain *legacy_irq_domain;
struct clk *clk;
@@ -625,7 +623,7 @@ static int nwl_pcie_bridge_init(struct nwl_pcie *pcie)
{
struct device *dev = pcie->dev;
struct platform_device *pdev = to_platform_device(dev);
- u32 breg_val, ecam_val, first_busno = 0;
+ u32 breg_val, ecam_val;
int err;
breg_val = nwl_bridge_readl(pcie, E_BREG_CAPABILITIES) & BREG_PRESENT;
@@ -675,7 +673,7 @@ static int nwl_pcie_bridge_init(struct nwl_pcie *pcie)
E_ECAM_CR_ENABLE, E_ECAM_CONTROL);
nwl_bridge_writel(pcie, nwl_bridge_readl(pcie, E_ECAM_CONTROL) |
- (pcie->ecam_value << E_ECAM_SIZE_SHIFT),
+ (NWL_ECAM_VALUE_DEFAULT << E_ECAM_SIZE_SHIFT),
E_ECAM_CONTROL);
nwl_bridge_writel(pcie, lower_32_bits(pcie->phys_ecam_base),
@@ -683,15 +681,6 @@ static int nwl_pcie_bridge_init(struct nwl_pcie *pcie)
nwl_bridge_writel(pcie, upper_32_bits(pcie->phys_ecam_base),
E_ECAM_BASE_HI);
- /* Get bus range */
- ecam_val = nwl_bridge_readl(pcie, E_ECAM_CONTROL);
- pcie->last_busno = (ecam_val & E_ECAM_SIZE_LOC) >> E_ECAM_SIZE_SHIFT;
- /* Write primary, secondary and subordinate bus numbers */
- ecam_val = first_busno;
- ecam_val |= (first_busno + 1) << 8;
- ecam_val |= (pcie->last_busno << E_ECAM_SIZE_SHIFT);
- writel(ecam_val, (pcie->ecam_base + PCI_PRIMARY_BUS));
-
if (nwl_pcie_link_up(pcie))
dev_info(dev, "Link is UP\n");
else
@@ -792,7 +781,6 @@ static int nwl_pcie_probe(struct platform_device *pdev)
pcie = pci_host_bridge_priv(bridge);
pcie->dev = dev;
- pcie->ecam_value = NWL_ECAM_VALUE_DEFAULT;
err = nwl_pcie_parse_dt(pcie, pdev);
if (err) {