This driver does not properly map jack pins to kcontrols that PulseAudio
and PipeWire need to handle jack detection events. It seems to have a
single detection GPIO pin used to report everything as a Headset. But it
has widgets for Headphone and Mic Jack, so expose both to userspace as
kcontrols.
Signed-off-by: Alper Nebi Yasak <alpernebiyasak@gmail.com>
---
Also see https://github.com/xobs/pulseaudio-novena though I don't
really understand PulseAudio configuration.
sound/soc/fsl/imx-es8328.c | 25 ++++++++++++++++++++++---
1 file changed, 22 insertions(+), 3 deletions(-)
@@ -37,6 +37,16 @@ static struct snd_soc_jack_gpio headset_jack_gpios[] = {
};
static struct snd_soc_jack headset_jack;
+static struct snd_soc_jack_pin headset_jack_pins[] = {
+ {
+ .pin = "Headphone",
+ .mask = SND_JACK_HEADPHONE,
+ },
+ {
+ .pin = "Mic Jack",
+ .mask = SND_JACK_MICROPHONE,
+ },
+};
static int imx_es8328_dai_init(struct snd_soc_pcm_runtime *rtd)
{
@@ -46,9 +56,11 @@ static int imx_es8328_dai_init(struct snd_soc_pcm_runtime *rtd)
/* Headphone jack detection */
if (gpio_is_valid(data->jack_gpio)) {
- ret = snd_soc_card_jack_new(rtd->card, "Headphone",
- SND_JACK_HEADPHONE | SND_JACK_BTN_0,
- &headset_jack);
+ ret = snd_soc_card_jack_new_pins(rtd->card, "Headphone",
+ SND_JACK_HEADSET | SND_JACK_BTN_0,
+ &headset_jack,
+ headset_jack_pins,
+ ARRAY_SIZE(headset_jack_pins));
if (ret)
return ret;
@@ -68,6 +80,11 @@ static const struct snd_soc_dapm_widget imx_es8328_dapm_widgets[] = {
SND_SOC_DAPM_REGULATOR_SUPPLY("audio-amp", 1, 0),
};
+static const struct snd_kcontrol_new imx_es8328_controls[] = {
+ SOC_DAPM_PIN_SWITCH("Headphone"),
+ SOC_DAPM_PIN_SWITCH("Mic Jack"),
+};
+
static int imx_es8328_probe(struct platform_device *pdev)
{
struct device_node *np = pdev->dev.of_node;
@@ -183,6 +200,8 @@ static int imx_es8328_probe(struct platform_device *pdev)
data->card.dev = dev;
data->card.dapm_widgets = imx_es8328_dapm_widgets;
data->card.num_dapm_widgets = ARRAY_SIZE(imx_es8328_dapm_widgets);
+ data->card.controls = imx_es8328_controls;
+ data->card.num_controls = ARRAY_SIZE(imx_es8328_controls);
ret = snd_soc_of_parse_card_name(&data->card, "model");
if (ret) {
dev_err(dev, "Unable to parse card name\n");