diff mbox series

[3/5] mtd: rawnand: qcom: Add support for param_page read exec_ops

Message ID 20230511130730.28689-3-quic_mdalam@quicinc.com
State New
Headers
Series [1/5] mtd: rawnand: qcom: Implement exec_op() |

Commit Message

Md Sadre Alam May 11, 2023, 1:07 p.m. UTC 
  This change will add exec_ops for PARAM_PAGE_READ command.

Co-developed-by: Sricharan Ramabadhran <quic_srichara@quicinc.com>
Signed-off-by: Sricharan Ramabadhran <quic_srichara@quicinc.com>
Signed-off-by: Md Sadre Alam <quic_mdalam@quicinc.com>
---
 drivers/mtd/nand/raw/qcom_nandc.c | 91 ++++++++++++++++++++++++++++++-
 1 file changed, 90 insertions(+), 1 deletion(-)
diff mbox series

Patch

diff --git a/drivers/mtd/nand/raw/qcom_nandc.c b/drivers/mtd/nand/raw/qcom_nandc.c
index d2f2a8971907..8717d5086f80 100644
--- a/drivers/mtd/nand/raw/qcom_nandc.c
+++ b/drivers/mtd/nand/raw/qcom_nandc.c
@@ -3086,7 +3086,96 @@  static int qcom_erase_cmd_type_exec(struct nand_chip *chip, const struct nand_su
 
 static int qcom_param_page_type_exec(struct nand_chip *chip,  const struct nand_subop *subop)
 {
-	return 0;
+	struct qcom_nand_host *host = to_qcom_nand_host(chip);
+	struct qcom_nand_controller *nandc = get_qcom_nand_controller(chip);
+	struct qcom_op q_op;
+	const struct nand_op_instr *instr = NULL;
+	unsigned int op_id = 0;
+	unsigned int len = 0;
+	int ret = 0;
+
+	qcom_parse_instructions(chip, subop, &q_op);
+
+	q_op.cmd_reg |= PAGE_ACC | LAST_PAGE;
+
+	pre_command(host, NAND_CMD_PARAM);
+	/*
+	 * NAND_CMD_PARAM is called before we know much about the FLASH chip
+	 * in use. we configure the controller to perform a raw read of 512
+	 * bytes to read onfi params
+	 */
+	if (nandc->props->qpic_v2)
+		nandc_set_reg(chip, NAND_FLASH_CMD, q_op.cmd_reg);
+	else
+		nandc_set_reg(chip, NAND_FLASH_CMD, q_op.cmd_reg);
+
+	nandc_set_reg(chip, NAND_ADDR0, 0);
+	nandc_set_reg(chip, NAND_ADDR1, 0);
+	nandc_set_reg(chip, NAND_DEV0_CFG0, 0 << CW_PER_PAGE
+					| 512 << UD_SIZE_BYTES
+					| 5 << NUM_ADDR_CYCLES
+					| 0 << SPARE_SIZE_BYTES);
+	nandc_set_reg(chip, NAND_DEV0_CFG1, 7 << NAND_RECOVERY_CYCLES
+					| 0 << CS_ACTIVE_BSY
+					| 17 << BAD_BLOCK_BYTE_NUM
+					| 1 << BAD_BLOCK_IN_SPARE_AREA
+					| 2 << WR_RD_BSY_GAP
+					| 0 << WIDE_FLASH
+					| 1 << DEV0_CFG1_ECC_DISABLE);
+	if (!nandc->props->qpic_v2)
+		nandc_set_reg(chip, NAND_EBI2_ECC_BUF_CFG, 1 << ECC_CFG_ECC_DISABLE);
+
+	/* configure CMD1 and VLD for ONFI param probing in QPIC v1 */
+	if (!nandc->props->qpic_v2) {
+		nandc_set_reg(chip, NAND_DEV_CMD_VLD,
+			      (nandc->vld & ~READ_START_VLD));
+		nandc_set_reg(chip, NAND_DEV_CMD1,
+			      (nandc->cmd1 & ~(0xFF << READ_ADDR))
+			      | NAND_CMD_PARAM << READ_ADDR);
+	}
+
+	nandc_set_reg(chip, NAND_EXEC_CMD, 1);
+
+	if (!nandc->props->qpic_v2) {
+		nandc_set_reg(chip, NAND_DEV_CMD1_RESTORE, nandc->cmd1);
+		nandc_set_reg(chip, NAND_DEV_CMD_VLD_RESTORE, nandc->vld);
+	}
+
+	nandc_set_read_loc(chip, 0, 0, 0, 512, 1);
+
+	if (!nandc->props->qpic_v2) {
+		write_reg_dma(nandc, NAND_DEV_CMD_VLD, 1, 0);
+		write_reg_dma(nandc, NAND_DEV_CMD1, 1, NAND_BAM_NEXT_SGL);
+	}
+
+	nandc->buf_count = 512;
+	memset(nandc->data_buffer, 0xff, nandc->buf_count);
+
+	config_nand_single_cw_page_read(chip, false, 0);
+
+	read_data_dma(nandc, FLASH_BUF_ACC, nandc->data_buffer,
+		      nandc->buf_count, 0);
+
+	/* restore CMD1 and VLD regs */
+	if (!nandc->props->qpic_v2) {
+		write_reg_dma(nandc, NAND_DEV_CMD1_RESTORE, 1, 0);
+		write_reg_dma(nandc, NAND_DEV_CMD_VLD_RESTORE, 1, NAND_BAM_NEXT_SGL);
+	}
+
+	ret = submit_descs(nandc);
+	if (ret)
+		dev_err(nandc->dev, "failure in sbumitting param page descriptor\n");
+
+	free_descs(nandc);
+
+	ret = qcom_wait_rdy_poll(chip, q_op.rdy_timeout_ms);
+
+	instr = q_op.data_instr;
+	op_id = q_op.data_instr_idx;
+	len = nand_subop_get_data_len(subop, op_id);
+	memcpy(instr->ctx.data.buf.in, nandc->data_buffer, len);
+
+	return ret;
 }
 
 static int qcom_read_id_type_exec(struct nand_chip *chip, const struct nand_subop *subop)