[v2,1/3] arm64: dts: ti: k3-j7200-mcu-wakeup: Remove 0x unit address prefix from nodename
Commit Message
From: Nishanth Menon <nm@ti.com>
unit-address should not use a 0x prefix.
Signed-off-by: Nishanth Menon <nm@ti.com>
Signed-off-by: Vaishnav Achath <vaishnav.a@ti.com>
---
V1->V2 : No changes.
arch/arm64/boot/dts/ti/k3-j7200-mcu-wakeup.dtsi | 6 +++---
1 file changed, 3 insertions(+), 3 deletions(-)
@@ -62,7 +62,7 @@
pinctrl-single,function-mask = <0xffffffff>;
};
- wkup_pmx1: pinctrl@0x4301c038 {
+ wkup_pmx1: pinctrl@4301c038 {
compatible = "pinctrl-single";
/* Proxy 0 addressing */
reg = <0x00 0x4301c038 0x00 0x8>;
@@ -71,7 +71,7 @@
pinctrl-single,function-mask = <0xffffffff>;
};
- wkup_pmx2: pinctrl@0x4301c068 {
+ wkup_pmx2: pinctrl@4301c068 {
compatible = "pinctrl-single";
/* Proxy 0 addressing */
reg = <0x00 0x4301c068 0x00 0xec>;
@@ -80,7 +80,7 @@
pinctrl-single,function-mask = <0xffffffff>;
};
- wkup_pmx3: pinctrl@0x4301c174 {
+ wkup_pmx3: pinctrl@4301c174 {
compatible = "pinctrl-single";
/* Proxy 0 addressing */
reg = <0x00 0x4301c174 0x00 0x20>;