cpufreq: qcom-hw: Simplify counting frequency domains
Commit Message
For quite some time, this driver has been doing performing some
quite low-level DT operations. Simplify that using
platform_get_resource.
Signed-off-by: Konrad Dybcio <konrad.dybcio@linaro.org>
---
drivers/cpufreq/qcom-cpufreq-hw.c | 28 ++++++----------------------
1 file changed, 6 insertions(+), 22 deletions(-)
@@ -29,6 +29,8 @@
#define GT_IRQ_STATUS BIT(2)
+#define MAX_FREQ_DOMAINS 3
+
struct qcom_cpufreq_soc_data {
u32 reg_enable;
u32 reg_domain_state;
@@ -651,10 +653,9 @@ static int qcom_cpufreq_hw_driver_probe(struct platform_device *pdev)
{
struct clk_hw_onecell_data *clk_data;
struct device *dev = &pdev->dev;
- struct device_node *soc_node;
struct device *cpu_dev;
struct clk *clk;
- int ret, i, num_domains, reg_sz;
+ int ret, i, num_domains;
clk = clk_get(dev, "xo");
if (IS_ERR(clk))
@@ -681,24 +682,9 @@ static int qcom_cpufreq_hw_driver_probe(struct platform_device *pdev)
if (ret)
return ret;
- /* Allocate qcom_cpufreq_data based on the available frequency domains in DT */
- soc_node = of_get_parent(dev->of_node);
- if (!soc_node)
- return -EINVAL;
-
- ret = of_property_read_u32(soc_node, "#address-cells", ®_sz);
- if (ret)
- goto of_exit;
-
- ret = of_property_read_u32(soc_node, "#size-cells", &i);
- if (ret)
- goto of_exit;
-
- reg_sz += i;
-
- num_domains = of_property_count_elems_of_size(dev->of_node, "reg", sizeof(u32) * reg_sz);
- if (num_domains <= 0)
- return num_domains;
+ for (num_domains = 0; num_domains < MAX_FREQ_DOMAINS; num_domains++)
+ if (!platform_get_resource(pdev, IORESOURCE_MEM, num_domains))
+ break;
qcom_cpufreq.data = devm_kzalloc(dev, sizeof(struct qcom_cpufreq_data) * num_domains,
GFP_KERNEL);
@@ -762,8 +748,6 @@ static int qcom_cpufreq_hw_driver_probe(struct platform_device *pdev)
else
dev_dbg(dev, "QCOM CPUFreq HW driver initialized\n");
-of_exit:
- of_node_put(soc_node);
return ret;
}