diff mbox series

[v12,08/11] Documentation: amd-pstate: add amd pstate driver mode introduction

Message ID 20230131090016.3970625-9-perry.yuan@amd.com
State New
Headers
Series Implement AMD Pstate EPP Driver |

Commit Message

Yuan, Perry Jan. 31, 2023, 9 a.m. UTC 
  From: Perry Yuan <Perry.Yuan@amd.com>

The amd-pstate driver has two operation modes supported:
* CPPC Autonomous (active) mode
* CPPC non-autonomous (passive) mode.
active mode and passive mode can be chosen by different kernel parameters.

Acked-by: Huang Rui <ray.huang@amd.com>
Reviewed-by: Mario Limonciello <mario.limonciello@amd.com>
Reviewed-by: Wyes Karny <wyes.karny@amd.com>
Tested-by: Wyes Karny <wyes.karny@amd.com>
Signed-off-by: Perry Yuan <Perry.Yuan@amd.com>
---
 Documentation/admin-guide/pm/amd-pstate.rst | 26 +++++++++++++++++++--
 1 file changed, 24 insertions(+), 2 deletions(-)
diff mbox series

Patch

diff --git a/Documentation/admin-guide/pm/amd-pstate.rst b/Documentation/admin-guide/pm/amd-pstate.rst
index 98a2bb44f80c..b6aee69f564f 100644
--- a/Documentation/admin-guide/pm/amd-pstate.rst
+++ b/Documentation/admin-guide/pm/amd-pstate.rst
@@ -299,8 +299,30 @@  module which supports the new AMD P-States mechanism on most of the future AMD
 platforms. The AMD P-States mechanism is the more performance and energy
 efficiency frequency management method on AMD processors.
 
-Kernel Module Options for ``amd-pstate``
-=========================================
+
+AMD Pstate Driver Operation Modes
+=================================
+
+``amd_pstate`` CPPC has two operation modes: CPPC Autonomous(active) mode and
+CPPC non-autonomous(passive) mode.
+active mode and passive mode can be chosen by different kernel parameters.
+When in Autonomous mode, CPPC ignores requests done in the Desired Performance
+Target register and takes into account only the values set to the Minimum requested
+performance, Maximum requested performance, and Energy Performance Preference
+registers. When Autonomous is disabled, it only considers the Desired Performance Target.
+
+Active Mode
+------------
+
+``amd_pstate=active``
+
+This is the low-level firmware control mode which is implemented by ``amd_pstate_epp``
+driver with ``amd_pstate=active`` passed to the kernel in the command line.
+In this mode, ``amd_pstate_epp`` driver provides a hint to the hardware if software
+wants to bias toward performance (0x0) or energy efficiency (0xff) to the CPPC firmware.
+then CPPC power algorithm will calculate the runtime workload and adjust the realtime
+cores frequency according to the power supply and thermal, core voltage and some other
+hardware conditions.
 
 Passive Mode
 ------------