diff mbox series

[4/6] arm64: dts: exynos: add VPH_PWR regulator on TM2

Message ID 20230120173116.341270-4-krzysztof.kozlowski@linaro.org
State New
Headers
Series [1/6] arm64: dts: exynos: disable non-working GPU on Exynos7 Espresso |

Commit Message

Krzysztof Kozlowski Jan. 20, 2023, 5:31 p.m. UTC 
  VPH_PWR is routed to battery, so it is not configurable.  However few
devices, e.g. WM5110 expect speaker power supplies, thus provide the
regulator for full hardware description.  Audio amplifier also accepts
that power supply.

Keep ordering the nodes by renaming existing IRDA regulator.

This fixes dtbs_check warnings:

  exynos5433-tm2e.dtb: audio-codec@0: 'SPKVDDL-supply' is a required property
  exynos5433-tm2e.dtb: audio-codec@0: 'SPKVDDR-supply' is a required property

Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
---
 .../boot/dts/exynos/exynos5433-tm2-common.dtsi      | 13 +++++++++++--
 1 file changed, 11 insertions(+), 2 deletions(-)
diff mbox series

Patch

diff --git a/arch/arm64/boot/dts/exynos/exynos5433-tm2-common.dtsi b/arch/arm64/boot/dts/exynos/exynos5433-tm2-common.dtsi
index 6f701297a665..3785a6580bdf 100644
--- a/arch/arm64/boot/dts/exynos/exynos5433-tm2-common.dtsi
+++ b/arch/arm64/boot/dts/exynos/exynos5433-tm2-common.dtsi
@@ -99,11 +99,18 @@  max98504: amplifier@31 {
 
 			DIOVDD-supply = <&ldo3_reg>;
 			DVDD-supply = <&ldo3_reg>;
-			/* PVDD-supply to VPH_PWR */
+			PVDD-supply = <&vph_pwr_regulator>;
 		};
 	};
 
-	irda_regulator: irda-regulator {
+	vph_pwr_regulator: regulator-vph-pwr {
+		compatible = "regulator-fixed";
+		regulator-name = "VPH_PWR";
+		regulator-min-microvolt = <4200000>;
+		regulator-max-microvolt = <4200000>;
+	};
+
+	irda_regulator: regulator-irda {
 		compatible = "regulator-fixed";
 		enable-active-high;
 		gpio = <&gpr3 3 GPIO_ACTIVE_HIGH>;
@@ -1298,6 +1305,8 @@  wm5110: audio-codec@0 {
 		CPVDD-supply = <&ldo18_reg>;
 		DBVDD2-supply = <&ldo18_reg>;
 		DBVDD3-supply = <&ldo18_reg>;
+		SPKVDDL-supply = <&vph_pwr_regulator>;
+		SPKVDDR-supply = <&vph_pwr_regulator>;
 
 		controller-data {
 			samsung,spi-feedback-delay = <0>;