diff mbox series

arm64: dts: imx8m{m,n}-venice-gw7902: add gpio pins for new board revision

Message ID 20221107181754.218158-1-tharvey@gateworks.com
State New
Headers
Series arm64: dts: imx8m{m,n}-venice-gw7902: add gpio pins for new board revision |

Commit Message

Tim Harvey Nov. 7, 2022, 6:17 p.m. UTC 
  Add gpio pins present on new board revision:
 * LTE modem support (imx8mm-gw7902 only)
  - lte_pwr#
  - lte_rst
  - lte_int
 * M2 power enable
  - m2_pwr_en
 * off-board 4.0V supply
  - vdd_4p0_en

Signed-off-by: Tim Harvey <tharvey@gateworks.com>
---
 .../boot/dts/freescale/imx8mm-venice-gw7902.dts      | 12 ++++++++----
 .../boot/dts/freescale/imx8mn-venice-gw7902.dts      |  8 ++++----
 2 files changed, 12 insertions(+), 8 deletions(-)

Comments

Shawn Guo Nov. 11, 2022, 7:10 a.m. UTC | #1 
On Mon, Nov 07, 2022 at 10:17:54AM -0800, Tim Harvey wrote:
> Add gpio pins present on new board revision:
>  * LTE modem support (imx8mm-gw7902 only)
>   - lte_pwr#
>   - lte_rst
>   - lte_int
>  * M2 power enable
>   - m2_pwr_en
>  * off-board 4.0V supply
>   - vdd_4p0_en
> 
> Signed-off-by: Tim Harvey <tharvey@gateworks.com>

Applied, thanks!
diff mbox series

Patch

diff --git a/arch/arm64/boot/dts/freescale/imx8mm-venice-gw7902.dts b/arch/arm64/boot/dts/freescale/imx8mm-venice-gw7902.dts
index 0359dca031c8..11481e09c75b 100644
--- a/arch/arm64/boot/dts/freescale/imx8mm-venice-gw7902.dts
+++ b/arch/arm64/boot/dts/freescale/imx8mm-venice-gw7902.dts
@@ -261,7 +261,7 @@  ethphy0: ethernet-phy@0 {
 
 &gpio1 {
 	gpio-line-names = "", "", "", "", "", "", "", "",
-		"", "", "", "", "", "m2_reset", "", "m2_wdis#",
+		"m2_pwr_en", "", "", "", "", "m2_reset", "", "m2_wdis#",
 		"", "", "", "", "", "", "", "",
 		"", "", "", "", "", "", "", "";
 };
@@ -283,7 +283,8 @@  &gpio3 {
 &gpio4 {
 	gpio-line-names = "", "", "", "", "", "", "", "",
 		"", "", "", "amp_gpio3", "amp_gpio2", "", "amp_gpio1", "",
-		"", "", "", "", "amp_gpio4", "app_gpio1", "", "uart1_rs485",
+		"lte_pwr#", "lte_rst", "lte_int", "",
+		"amp_gpio4", "app_gpio1", "vdd_4p0_en", "uart1_rs485",
 		"", "uart1_term", "uart1_half", "app_gpio2",
 		"mipi_gpio1", "", "", "";
 };
@@ -750,14 +751,19 @@  &iomuxc {
 	pinctrl_hog: hoggrp {
 		fsl,pins = <
 			MX8MM_IOMUXC_NAND_CE0_B_GPIO3_IO1	0x40000159 /* M2_GDIS# */
+			MX8MM_IOMUXC_GPIO1_IO08_GPIO1_IO8	0x40000041 /* M2_PWR_EN */
 			MX8MM_IOMUXC_GPIO1_IO13_GPIO1_IO13	0x40000041 /* M2_RESET */
 			MX8MM_IOMUXC_NAND_DATA01_GPIO3_IO7	0x40000119 /* M2_OFF# */
 			MX8MM_IOMUXC_GPIO1_IO15_GPIO1_IO15	0x40000159 /* M2_WDIS# */
+			MX8MM_IOMUXC_SAI1_TXD6_GPIO4_IO18       0x40000041 /* LTE_INT */
+			MX8MM_IOMUXC_SAI1_TXD5_GPIO4_IO17       0x40000041 /* LTE_RST# */
+			MX8MM_IOMUXC_SAI1_TXD4_GPIO4_IO16       0x40000041 /* LTE_PWR */
 			MX8MM_IOMUXC_SAI1_TXD2_GPIO4_IO14	0x40000041 /* AMP GPIO1 */
 			MX8MM_IOMUXC_SAI1_TXD0_GPIO4_IO12	0x40000041 /* AMP GPIO2 */
 			MX8MM_IOMUXC_SAI1_TXC_GPIO4_IO11	0x40000041 /* AMP GPIO3 */
 			MX8MM_IOMUXC_SAI1_MCLK_GPIO4_IO20	0x40000041 /* AMP_GPIO4 */
 			MX8MM_IOMUXC_SAI2_RXFS_GPIO4_IO21	0x40000041 /* APP GPIO1 */
+			MX8MM_IOMUXC_SAI2_RXC_GPIO4_IO22	0x40000041 /* VDD_4P0_EN */
 			MX8MM_IOMUXC_SAI2_MCLK_GPIO4_IO27	0x40000041 /* APP GPIO2 */
 			MX8MM_IOMUXC_SD1_DATA6_GPIO2_IO8	0x40000041 /* UART2_EN# */
 			MX8MM_IOMUXC_SAI3_RXFS_GPIO4_IO28	0x40000041 /* MIPI_GPIO1 */
@@ -791,8 +797,6 @@  MX8MM_IOMUXC_ENET_RX_CTL_ENET1_RGMII_RX_CTL	0x91
 			MX8MM_IOMUXC_ENET_TX_CTL_ENET1_RGMII_TX_CTL	0x1f
 			MX8MM_IOMUXC_GPIO1_IO10_GPIO1_IO10		0x19 /* RST# */
 			MX8MM_IOMUXC_GPIO1_IO11_GPIO1_IO11		0x19 /* IRQ# */
-			MX8MM_IOMUXC_GPIO1_IO08_ENET1_1588_EVENT0_IN	0x141
-			MX8MM_IOMUXC_GPIO1_IO09_ENET1_1588_EVENT0_OUT	0x141
 		>;
 	};
 
diff --git a/arch/arm64/boot/dts/freescale/imx8mn-venice-gw7902.dts b/arch/arm64/boot/dts/freescale/imx8mn-venice-gw7902.dts
index 187e0410b87d..97582db71ca8 100644
--- a/arch/arm64/boot/dts/freescale/imx8mn-venice-gw7902.dts
+++ b/arch/arm64/boot/dts/freescale/imx8mn-venice-gw7902.dts
@@ -256,7 +256,7 @@  ethphy0: ethernet-phy@0 {
 
 &gpio1 {
 	gpio-line-names = "", "", "", "", "", "", "", "",
-		"", "", "", "", "", "m2_reset", "", "m2_wdis#",
+		"m2_pwr_en", "", "", "", "", "m2_reset", "", "m2_wdis#",
 		"", "", "", "", "", "", "", "",
 		"", "", "", "", "", "", "", "";
 };
@@ -278,7 +278,7 @@  &gpio3 {
 &gpio4 {
 	gpio-line-names = "", "", "", "", "", "", "", "",
 		"", "", "", "", "", "", "", "",
-		"", "", "", "", "", "app_gpio1", "", "uart1_rs485",
+		"", "", "", "", "", "app_gpio1", "vdd_4p0_en", "uart1_rs485",
 		"", "uart1_term", "uart1_half", "app_gpio2",
 		"mipi_gpio1", "", "", "";
 };
@@ -701,10 +701,12 @@  &iomuxc {
 	pinctrl_hog: hoggrp {
 		fsl,pins = <
 			MX8MN_IOMUXC_NAND_CE0_B_GPIO3_IO1	0x40000159 /* M2_GDIS# */
+			MX8MN_IOMUXC_GPIO1_IO08_GPIO1_IO8	0x40000041 /* M2_PWR_EN */
 			MX8MN_IOMUXC_GPIO1_IO13_GPIO1_IO13	0x40000041 /* M2_RESET */
 			MX8MN_IOMUXC_NAND_DATA01_GPIO3_IO7	0x40000119 /* M2_OFF# */
 			MX8MN_IOMUXC_GPIO1_IO15_GPIO1_IO15	0x40000159 /* M2_WDIS# */
 			MX8MN_IOMUXC_SAI2_RXFS_GPIO4_IO21	0x40000041 /* APP GPIO1 */
+			MX8MN_IOMUXC_SAI2_RXC_GPIO4_IO22	0x40000041 /* VDD_4P0_EN */
 			MX8MN_IOMUXC_SAI2_MCLK_GPIO4_IO27	0x40000041 /* APP GPIO2 */
 			MX8MN_IOMUXC_SD1_DATA6_GPIO2_IO8	0x40000041 /* UART2_EN# */
 			MX8MN_IOMUXC_SAI3_RXFS_GPIO4_IO28	0x40000041 /* MIPI_GPIO1 */
@@ -738,8 +740,6 @@  MX8MN_IOMUXC_ENET_RX_CTL_ENET1_RGMII_RX_CTL	0x91
 			MX8MN_IOMUXC_ENET_TX_CTL_ENET1_RGMII_TX_CTL	0x1f
 			MX8MN_IOMUXC_GPIO1_IO10_GPIO1_IO10		0x19 /* RST# */
 			MX8MN_IOMUXC_GPIO1_IO11_GPIO1_IO11		0x19 /* IRQ# */
-			MX8MN_IOMUXC_GPIO1_IO08_ENET1_1588_EVENT0_IN	0x141
-			MX8MN_IOMUXC_GPIO1_IO09_ENET1_1588_EVENT0_OUT	0x141
 		>;
 	};