[05/13] mm: Rename GUP_GET_PTE_LOW_HIGH
Commit Message
Since it no longer applies to only PTEs, rename it to PXX.
Suggested-by: Linus Torvalds <torvalds@linux-foundation.org>
Signed-off-by: Peter Zijlstra (Intel) <peterz@infradead.org>
---
arch/mips/Kconfig | 2 +-
arch/sh/Kconfig | 2 +-
arch/x86/Kconfig | 2 +-
include/linux/pgtable.h | 4 ++--
mm/Kconfig | 2 +-
5 files changed, 6 insertions(+), 6 deletions(-)
@@ -46,7 +46,7 @@ config MIPS
select GENERIC_SCHED_CLOCK if !CAVIUM_OCTEON_SOC
select GENERIC_SMP_IDLE_THREAD
select GENERIC_TIME_VSYSCALL
- select GUP_GET_PTE_LOW_HIGH if CPU_MIPS32 && PHYS_ADDR_T_64BIT
+ select GUP_GET_PXX_LOW_HIGH if CPU_MIPS32 && PHYS_ADDR_T_64BIT
select HAVE_ARCH_COMPILER_H
select HAVE_ARCH_JUMP_LABEL
select HAVE_ARCH_KGDB if MIPS_FP_SUPPORT
@@ -24,7 +24,7 @@ config SUPERH
select GENERIC_PCI_IOMAP if PCI
select GENERIC_SCHED_CLOCK
select GENERIC_SMP_IDLE_THREAD
- select GUP_GET_PTE_LOW_HIGH if X2TLB
+ select GUP_GET_PXX_LOW_HIGH if X2TLB
select HAVE_ARCH_AUDITSYSCALL
select HAVE_ARCH_KGDB
select HAVE_ARCH_SECCOMP_FILTER
@@ -157,7 +157,7 @@ config X86
select GENERIC_TIME_VSYSCALL
select GENERIC_GETTIMEOFDAY
select GENERIC_VDSO_TIME_NS
- select GUP_GET_PTE_LOW_HIGH if X86_PAE
+ select GUP_GET_PXX_LOW_HIGH if X86_PAE
select HARDIRQS_SW_RESEND
select HARDLOCKUP_CHECK_TIMESTAMP if X86_64
select HAVE_ACPI_APEI if ACPI
@@ -305,7 +305,7 @@ static inline pmd_t pmdp_get(pmd_t *pmdp
}
#endif
-#ifdef CONFIG_GUP_GET_PTE_LOW_HIGH
+#ifdef CONFIG_GUP_GET_PXX_LOW_HIGH
/*
* For walking the pagetables without holding any locks. Some architectures
* (eg x86-32 PAE) cannot load the entries atomically without using expensive
@@ -365,7 +365,7 @@ static inline pmd_t pmdp_get_lockless(pm
}
#define pmdp_get_lockless pmdp_get_lockless
#endif /* CONFIG_PGTABLE_LEVELS > 2 */
-#endif /* CONFIG_GUP_GET_PTE_LOW_HIGH */
+#endif /* CONFIG_GUP_GET_PXX_LOW_HIGH */
/*
* We require that the PTE can be read atomically.
@@ -1044,7 +1044,7 @@ config GUP_TEST
comment "GUP_TEST needs to have DEBUG_FS enabled"
depends on !GUP_TEST && !DEBUG_FS
-config GUP_GET_PTE_LOW_HIGH
+config GUP_GET_PXX_LOW_HIGH
bool
config ARCH_HAS_PTE_SPECIAL