Always define the POWER_DOWN_CONTROL register instead of falling back to
the v2 (and v4) offset during power on and power off.
Reviewed-by: Dmitry Baryshkov <dmitry.baryshkov@linaro.org>
Signed-off-by: Johan Hovold <johan+linaro@kernel.org>
---
drivers/phy/qualcomm/phy-qcom-qmp-ufs.c | 22 ++++++++--------------
1 file changed, 8 insertions(+), 14 deletions(-)
@@ -89,22 +89,26 @@ enum qphy_reg_layout {
static const unsigned int msm8996_ufsphy_regs_layout[QPHY_LAYOUT_SIZE] = {
[QPHY_START_CTRL] = 0x00,
[QPHY_PCS_READY_STATUS] = 0x168,
+ [QPHY_PCS_POWER_DOWN_CONTROL] = 0x04,
};
static const unsigned int sdm845_ufsphy_regs_layout[QPHY_LAYOUT_SIZE] = {
[QPHY_START_CTRL] = 0x00,
[QPHY_PCS_READY_STATUS] = 0x160,
+ [QPHY_PCS_POWER_DOWN_CONTROL] = 0x04,
};
static const unsigned int sm6115_ufsphy_regs_layout[QPHY_LAYOUT_SIZE] = {
[QPHY_START_CTRL] = 0x00,
[QPHY_PCS_READY_STATUS] = 0x168,
+ [QPHY_PCS_POWER_DOWN_CONTROL] = 0x04,
};
static const unsigned int sm8150_ufsphy_regs_layout[QPHY_LAYOUT_SIZE] = {
[QPHY_START_CTRL] = QPHY_V4_PCS_UFS_PHY_START,
[QPHY_PCS_READY_STATUS] = QPHY_V4_PCS_UFS_READY_STATUS,
[QPHY_SW_RESET] = QPHY_V4_PCS_UFS_SW_RESET,
+ [QPHY_PCS_POWER_DOWN_CONTROL] = QPHY_V4_PCS_UFS_POWER_DOWN_CONTROL,
};
static const struct qmp_phy_init_tbl msm8996_ufs_serdes_tbl[] = {
@@ -856,13 +860,8 @@ static int qmp_ufs_com_init(struct qmp_phy *qphy)
if (ret)
goto err_disable_regulators;
- if (cfg->regs[QPHY_PCS_POWER_DOWN_CONTROL])
- qphy_setbits(pcs,
- cfg->regs[QPHY_PCS_POWER_DOWN_CONTROL],
- cfg->pwrdn_ctrl);
- else
- qphy_setbits(pcs, QPHY_V2_PCS_POWER_DOWN_CONTROL,
- cfg->pwrdn_ctrl);
+ qphy_setbits(pcs, cfg->regs[QPHY_PCS_POWER_DOWN_CONTROL],
+ cfg->pwrdn_ctrl);
return 0;
@@ -996,13 +995,8 @@ static int qmp_ufs_power_off(struct phy *phy)
qphy_clrbits(qphy->pcs, cfg->regs[QPHY_START_CTRL], cfg->start_ctrl);
/* Put PHY into POWER DOWN state: active low */
- if (cfg->regs[QPHY_PCS_POWER_DOWN_CONTROL]) {
- qphy_clrbits(qphy->pcs, cfg->regs[QPHY_PCS_POWER_DOWN_CONTROL],
- cfg->pwrdn_ctrl);
- } else {
- qphy_clrbits(qphy->pcs, QPHY_V2_PCS_POWER_DOWN_CONTROL,
- cfg->pwrdn_ctrl);
- }
+ qphy_clrbits(qphy->pcs, cfg->regs[QPHY_PCS_POWER_DOWN_CONTROL],
+ cfg->pwrdn_ctrl);
return 0;
}