[tip:,x86/boot] m68k/cpu: Switch to arch_cpu_finalize_init()
Commit Message
The following commit has been merged into the x86/boot branch of tip:
Commit-ID: 9ceecc2589b9d7cef6b321339ed8de484eac4b20
Gitweb: https://git.kernel.org/tip/9ceecc2589b9d7cef6b321339ed8de484eac4b20
Author: Thomas Gleixner <tglx@linutronix.de>
AuthorDate: Wed, 14 Jun 2023 01:39:30 +02:00
Committer: Thomas Gleixner <tglx@linutronix.de>
CommitterDate: Fri, 16 Jun 2023 10:15:59 +02:00
m68k/cpu: Switch to arch_cpu_finalize_init()
check_bugs() is about to be phased out. Switch over to the new
arch_cpu_finalize_init() implementation.
No functional change.
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
Acked-by: Geert Uytterhoeven <geert@linux-m68k.org>
Link: https://lore.kernel.org/r/20230613224545.254342916@linutronix.de
---
arch/m68k/Kconfig | 1 +
arch/m68k/include/asm/bugs.h | 21 ---------------------
arch/m68k/kernel/setup_mm.c | 3 ++-
3 files changed, 3 insertions(+), 22 deletions(-)
delete mode 100644 arch/m68k/include/asm/bugs.h
@@ -4,6 +4,7 @@ config M68K
default y
select ARCH_32BIT_OFF_T
select ARCH_HAS_BINFMT_FLAT
+ select ARCH_HAS_CPU_FINALIZE_INIT if MMU
select ARCH_HAS_CURRENT_STACK_POINTER
select ARCH_HAS_DMA_PREP_COHERENT if HAS_DMA && MMU && !COLDFIRE
select ARCH_HAS_SYNC_DMA_FOR_DEVICE if HAS_DMA
deleted file mode 100644
@@ -1,21 +0,0 @@
-/* SPDX-License-Identifier: GPL-2.0 */
-/*
- * include/asm-m68k/bugs.h
- *
- * Copyright (C) 1994 Linus Torvalds
- */
-
-/*
- * This is included by init/main.c to check for architecture-dependent bugs.
- *
- * Needs:
- * void check_bugs(void);
- */
-
-#ifdef CONFIG_MMU
-extern void check_bugs(void); /* in arch/m68k/kernel/setup.c */
-#else
-static void check_bugs(void)
-{
-}
-#endif
@@ -10,6 +10,7 @@
*/
#include <linux/kernel.h>
+#include <linux/cpu.h>
#include <linux/mm.h>
#include <linux/sched.h>
#include <linux/delay.h>
@@ -504,7 +505,7 @@ static int __init proc_hardware_init(void)
module_init(proc_hardware_init);
#endif
-void check_bugs(void)
+void __init arch_cpu_finalize_init(void)
{
#if defined(CONFIG_FPU) && !defined(CONFIG_M68KFPU_EMU)
if (m68k_fputype == 0) {