[v4,1/3] dt-bindings: PCI: qcom: ep: Add interconnects path
Commit Message
Some platforms may not boot if a device driver doesn't
initialize the interconnect path. Mostly it is handled
by the bootloader but we have starting to see cases
where bootloader simply ignores them.
Add the "pcie-mem" interconnect path as a required property
to the bindings.
Signed-off-by: Krishna chaitanya chundru <quic_krichai@quicinc.com>
---
Documentation/devicetree/bindings/pci/qcom,pcie-ep.yaml | 13 +++++++++++++
1 file changed, 13 insertions(+)
Comments
On 14/06/2023 16:24, Krishna chaitanya chundru wrote:
> Some platforms may not boot if a device driver doesn't
> initialize the interconnect path. Mostly it is handled
> by the bootloader but we have starting to see cases
> where bootloader simply ignores them.
>
> Add the "pcie-mem" interconnect path as a required property
> to the bindings.
>
I did not receive third patch in the series, so I hope you corrected all
DTS in the linux-next (sdx55, sdx65).
Reviewed-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
Best regards,
Krzysztof
@@ -70,6 +70,13 @@ properties:
description: GPIO used as WAKE# output signal
maxItems: 1
+ interconnects:
+ maxItems: 1
+
+ interconnect-names:
+ items:
+ - const: pcie-mem
+
resets:
maxItems: 1
@@ -97,6 +104,8 @@ required:
- interrupts
- interrupt-names
- reset-gpios
+ - interconnects
+ - interconnect-names
- resets
- reset-names
- power-domains
@@ -165,7 +174,9 @@ examples:
- |
#include <dt-bindings/clock/qcom,gcc-sdx55.h>
#include <dt-bindings/gpio/gpio.h>
+ #include <dt-bindings/interconnect/qcom,sdx55.h>
#include <dt-bindings/interrupt-controller/arm-gic.h>
+
pcie_ep: pcie-ep@1c00000 {
compatible = "qcom,sdx55-pcie-ep";
reg = <0x01c00000 0x3000>,
@@ -192,6 +203,8 @@ examples:
interrupts = <GIC_SPI 140 IRQ_TYPE_LEVEL_HIGH>,
<GIC_SPI 145 IRQ_TYPE_LEVEL_HIGH>;
interrupt-names = "global", "doorbell";
+ interconnects = <&system_noc MASTER_PCIE &mc_virt SLAVE_EBI_CH0>;
+ interconnect-names = "pcie-mem";
reset-gpios = <&tlmm 57 GPIO_ACTIVE_LOW>;
wake-gpios = <&tlmm 53 GPIO_ACTIVE_LOW>;
resets = <&gcc GCC_PCIE_BCR>;