[tip:,timers/core] clocksource: Verify HPET and PMTMR when TSC unverified
Commit Message
The following commit has been merged into the timers/core branch of tip:
Commit-ID: efc8b329c7fdc30921a7dfc109237523e1e5b1cc
Gitweb: https://git.kernel.org/tip/efc8b329c7fdc30921a7dfc109237523e1e5b1cc
Author: Paul E. McKenney <paulmck@kernel.org>
AuthorDate: Wed, 21 Dec 2022 16:20:25 -08:00
Committer: Paul E. McKenney <paulmck@kernel.org>
CommitterDate: Thu, 02 Feb 2023 14:23:02 -08:00
clocksource: Verify HPET and PMTMR when TSC unverified
On systems with two or fewer sockets, when the boot CPU has CONSTANT_TSC,
NONSTOP_TSC, and TSC_ADJUST, clocksource watchdog verification of the
TSC is disabled. This works well much of the time, but there is the
occasional production-level system that meets all of these criteria, but
which still has a TSC that skews significantly from atomic-clock time.
This is usually attributed to a firmware or hardware fault. Yes, the
various NTP daemons do express their opinions of userspace-to-atomic-clock
time skew, but they put them in various places, depending on the daemon
and distro in question. It would therefore be good for the kernel to
have some clue that there is a problem.
The old behavior of marking the TSC unstable is a non-starter because a
great many workloads simply cannot tolerate the overheads and latencies
of the various non-TSC clocksources. In addition, NTP-corrected systems
sometimes can tolerate significant kernel-space time skew as long as
the userspace time sources are within epsilon of atomic-clock time.
Therefore, when watchdog verification of TSC is disabled, enable it for
HPET and PMTMR (AKA ACPI PM timer). This provides the needed in-kernel
time-skew diagnostic without degrading the system's performance.
Signed-off-by: Paul E. McKenney <paulmck@kernel.org>
Cc: Thomas Gleixner <tglx@linutronix.de>
Cc: Ingo Molnar <mingo@redhat.com>
Cc: Borislav Petkov <bp@alien8.de>
Cc: Dave Hansen <dave.hansen@linux.intel.com>
Cc: "H. Peter Anvin" <hpa@zytor.com>
Cc: Daniel Lezcano <daniel.lezcano@linaro.org>
Cc: Waiman Long <longman@redhat.com>
Cc: <x86@kernel.org>
Tested-by: Feng Tang <feng.tang@intel.com>
---
arch/x86/include/asm/time.h | 1 +
arch/x86/kernel/hpet.c | 2 ++
arch/x86/kernel/tsc.c | 5 +++++
drivers/clocksource/acpi_pm.c | 6 ++++--
4 files changed, 12 insertions(+), 2 deletions(-)
@@ -8,6 +8,7 @@
extern void hpet_time_init(void);
extern void time_init(void);
extern bool pit_timer_init(void);
+extern bool tsc_clocksource_watchdog_disabled(void);
extern struct clock_event_device *global_clock_event;
@@ -1091,6 +1091,8 @@ int __init hpet_enable(void)
if (!hpet_counting())
goto out_nohpet;
+ if (tsc_clocksource_watchdog_disabled())
+ clocksource_hpet.flags |= CLOCK_SOURCE_MUST_VERIFY;
clocksource_register_hz(&clocksource_hpet, (u32)hpet_freq);
if (id & HPET_ID_LEGSUP) {
@@ -1190,6 +1190,11 @@ static void __init tsc_disable_clocksource_watchdog(void)
clocksource_tsc.flags &= ~CLOCK_SOURCE_MUST_VERIFY;
}
+bool tsc_clocksource_watchdog_disabled(void)
+{
+ return !(clocksource_tsc.flags & CLOCK_SOURCE_MUST_VERIFY);
+}
+
static void __init check_system_tsc_reliable(void)
{
#if defined(CONFIG_MGEODEGX1) || defined(CONFIG_MGEODE_LX) || defined(CONFIG_X86_GENERIC)
@@ -23,6 +23,7 @@
#include <linux/pci.h>
#include <linux/delay.h>
#include <asm/io.h>
+#include <asm/time.h>
/*
* The I/O port the PMTMR resides at.
@@ -210,8 +211,9 @@ static int __init init_acpi_pm_clocksource(void)
return -ENODEV;
}
- return clocksource_register_hz(&clocksource_acpi_pm,
- PMTMR_TICKS_PER_SEC);
+ if (tsc_clocksource_watchdog_disabled())
+ clocksource_acpi_pm.flags |= CLOCK_SOURCE_MUST_VERIFY;
+ return clocksource_register_hz(&clocksource_acpi_pm, PMTMR_TICKS_PER_SEC);
}
/* We use fs_initcall because we want the PCI fixups to have run