mbox series

[0/3] net: ethernet: ti: am65-cpsw: Allow for MTU values

Message ID 20240102081825.14635-1-jorge.sanjuangarcia@duagon.com
Headers
Series net: ethernet: ti: am65-cpsw: Allow for MTU values |

Message

Sanjuán García, Jorge Jan. 2, 2024, 8:19 a.m. UTC 
  The am65-cpsw-nuss driver has a fixed definition for the maximum ethernet
frame length of 1522 bytes (AM65_CPSW_MAX_PACKET_SIZE). This limits the switch
ports to only operate at a maximum MTU of 1500 bytes. When combining this CPSW
switch with a DSA switch connected to one of its ports this limitation shows up.
The extra 8 bytes the DSA subsystem adds internally to the ethernet frame
create resulting frames bigger than 1522 bytes (1518 for non VLAN + 8 for DSA
stuff) so they get dropped by the switch.

One of the issues with the the am65-cpsw-nuss driver is that the network device
max_mtu was being set to the same fixed value defined for the max total frame
length (1522 bytes). This makes the DSA subsystem believe that the MTU of the
interface can be set to 1508 bytes to make room for the extra 8 bytes of the DSA
headers. However, all packages created assuming the 1500 bytes payload get
dropped by the switch as oversized.

This series offers a solution to this problem. First, the max_mtu advertised on
the network device and the actual max frame size configured on the switch
registers are made consistent by letting the extra room needed for the ethernet
headers and the frame checksum (22 bytes including VLAN). Also, make the max
frame length configurable via a devicetree property to allow for MTU values
greater than 1500 bytes.

Jorge Sanjuan Garcia (3):
  net: ethernet: ti: am65-cpsw: Fix max mtu to fit ethernet frames
  net: ethernet: ti: am65-cpsw: Introduce rx_packet_max member
  net: ethernet: ti: am65-cpsw: Add device tree property to set max MTU

 drivers/net/ethernet/ti/am65-cpsw-nuss.c | 26 ++++++++++++++++++------
 drivers/net/ethernet/ti/am65-cpsw-nuss.h |  3 +++
 2 files changed, 23 insertions(+), 6 deletions(-)