mbox series

[v6,0/5] Add peripherals for J784S4

Message ID 20230721132029.123881-1-j-choudhary@ti.com
Headers
Series Add peripherals for J784S4 |

Message

Jayesh Choudhary July 21, 2023, 1:20 p.m. UTC 
  This series adds support for:
- SERDES, WIZ DT nodes, Serdes lane control mux
- MAIN CPSW2G nodes
- DSS and DisplayPort-0 nodes

This support DEPENDS upon another series which was introduced as part
of discussion in v5. That series[1] moves the ti-serdes headers file
from bindings to "arch/arm64/boot/dts/ti". (That series is ACKED and
REVIEWED)

Changelog v5->v6:
- Change header file according to [1].
- Add idle-state property in serdes_ln_ctrl node.
- Fix dtbs_check warning due to clock-frequency property in serdes_refclk
  node by disabling the node in main.dtsi and enabling it in board file
  when the clock-frequency node is actually added.

Changelog v4->v5:
- rebased the patches on linux-next tip.

Changelog v3->v4:
- add reg property to serdes_ln_ctrl and fix the node name again to
  get rid of dtbs_check error.
- reorder reg, reg-names and ranges property for main_cpsw1.
- correct the order for clocks in serdes_wiz nodes to fix dtbs_check
  warnings.
- fix indentation in reg, reg-names and clock property for dss node.
- add comments for the reg type in dss registers.

Changelog v3->v2:
- fix dtc warnings for 'scm_conf' and 'serdes_ln_ctrl' nodes
  (Checked all the changes of the series with W=12 option during build)
- added clock-frequency for serdes_refclk along with other EVM changes
  This refclk is being used by all the instances of serdes_wiz which
  are disabled by default. So configuring refclk when the serdes nodes
  are used for the first time is okay.

Changelog v1->v2:
- Moved J784S4 EVM changes together to the last patch
  (Suggested by Andrew)

v5 patch link:
<https://lore.kernel.org/all/20230710101705.154119-1-j-choudhary@ti.com/>

[1]: <https://lore.kernel.org/all/20230721125732.122421-1-j-choudhary@ti.com/>

Rahul T R (2):
  arm64: dts: ti: k3-j784s4-main: Add DSS and DP-bridge node
  arm64: dts: ti: k3-j784s4-evm: Enable DisplayPort-0

Siddharth Vadapalli (3):
  arm64: dts: ti: k3-j784s4-main: Add system controller and SERDES lane
    mux
  arm64: dts: ti: k3-j784s4: Add Main CPSW2G node
  arm64: dts: ti: k3-j784s4: Add WIZ and SERDES PHY nodes

 arch/arm64/boot/dts/ti/k3-j784s4-evm.dts   | 165 ++++++++++
 arch/arm64/boot/dts/ti/k3-j784s4-main.dtsi | 353 +++++++++++++++++++++
 2 files changed, 518 insertions(+)