mbox series

[net-next,0/2] net: dsa: mv88e6xxx: add 88E6361 support

Message ID 20230517203430.448705-1-alexis.lothore@bootlin.com
Headers
Series net: dsa: mv88e6xxx: add 88E6361 support |

Message

Alexis Lothoré May 17, 2023, 8:34 p.m. UTC 
  From: Alexis Lothoré <alexis.lothore@bootlin.com>

This series brings initial support for Marvell 88E6361 switch.

MV88E6361 is a 8 ports switch with 5 integrated Gigabit PHYs and 3
2.5Gigabit SerDes interfaces. It is in fact a new variant in the
88E639X/88E6193X/88E6191X family with a subset of existing features (e.g.
reduced ports count, lower maximal speed for MII interfaces).
Since said family is already well supported in mv88e6xxx driver, adding
initial support for this new switch mostly consists in finding the ID
exposed in its identification register, and then add a proper description
in switch description tables in mv88e6xxx driver.

This initial support has been tested with two samples of a custom board
with the following hardware configuration:
- a main CPU connected to MV88E6361 using port 0 as CPU port
- port 9 wired to a SFP cage
- port 10 wired to a G.Hn transceiver

The following setup was used:
PC <-ethernet-> (copper SFP) - Board 1 - (G.hn) <-phone line(RJ11)-> (G.hn) Board 2

The unit 1 has been configured to bridge SFP port and G.hn port together,
which allowed to successfully ping Board 2 from PC.

Alexis Lothoré (2):
  dt-bindings: net: dsa: marvell: add MV88E6361 switch to compatibility
    list
  net: dsa: mv88e6xxx: enable support for 88E6361 switch

 .../devicetree/bindings/net/dsa/marvell.txt   |  2 +-
 drivers/net/dsa/mv88e6xxx/chip.c              | 25 +++++++++++++++++++
 drivers/net/dsa/mv88e6xxx/chip.h              |  3 ++-
 drivers/net/dsa/mv88e6xxx/port.h              |  1 +
 4 files changed, 29 insertions(+), 2 deletions(-)