mbox series

[RESEND,V3,0/3] AM68 SK: Add initial support

Message ID 20230110110052.14851-1-sinthu.raja@ti.com
Headers
Series AM68 SK: Add initial support |

Message

Sinthu Raja Jan. 10, 2023, 11 a.m. UTC 
  From: Sinthu Raja <sinthu.raja@ti.com>

Hi All,
Respinning this series after rebasing to 6.2.rc1. Added all the tags.

This series of patches add support for AM68 Starter kit(SK). AM68 SK
is a low cost, small form factor board designed for TI’s J721S2/AM68 SoC.

Refer below link to J721S2/AM68 Technical Reference Manual for further 
details:
http://www.ti.com/lit/pdf/spruj28

Design files can be referrred from https://www.ti.com/lit/zip/SPRR463

Changes in  V3:
Address all the review comments.
 - Remove the unused nodes that are disabled by default.
 - Update the gpio regulator node: gpio-regulator-tlv to "regulator-tlv".

V1: https://lore.kernel.org/linux-arm-kernel/20221018123849.23695-1-sinthu.raja@ti.com/t/#mbe43b02221733bb6eb06b203359e90ec08406afc
V2: https://lore.kernel.org/lkml/20221107123852.8063-1-sinthu.raja@ti.com/

Sinthu Raja (3):
  dt-bindings: arm: ti: Add binding for AM68 SK
  arm64: dts: ti: Add initial support for AM68 SK System on Module
  arm64: dts: ti: k3-am68-sk: Add support for AM68 SK base board

 .../devicetree/bindings/arm/ti/k3.yaml        |   1 +
 arch/arm64/boot/dts/ti/Makefile               |   2 +
 .../boot/dts/ti/k3-am68-sk-base-board.dts     | 335 ++++++++++++++++++
 arch/arm64/boot/dts/ti/k3-am68-sk-som.dtsi    |  31 ++
 4 files changed, 369 insertions(+)
 create mode 100644 arch/arm64/boot/dts/ti/k3-am68-sk-base-board.dts
 create mode 100644 arch/arm64/boot/dts/ti/k3-am68-sk-som.dtsi