[pushed] aarch64: Fix SMSTART/SMSTOP save/restore for BE
Checks
Commit Message
VNx16QI (the SVE register byte mode) is the only SVE mode for which
LD1 and LDR result in the same register layout for big-endian. It is
therefore the only mode for which we allow LDR and STR to be used for
big-endian SVE moves.
The SME support sometimes needs to use LDR and STR to save and restore
Z register contents around an SMSTART/SMSTOP SM. It therefore needs
to use VNx16QI regardless of the type of value that is stored in the
Z registers.
Tested on aarch64-linux-gnu and aarch64_be-elf, pushed to trunk.
Richard
gcc/
PR target/112930
* config/aarch64/aarch64.cc (aarch64_sme_mode_switch_regs::add_reg):
Force specific SVE modes for single registers as well as structures.
---
gcc/config/aarch64/aarch64.cc | 15 +++++++++------
1 file changed, 9 insertions(+), 6 deletions(-)
@@ -4956,14 +4956,17 @@ aarch64_sme_mode_switch_regs::add_reg (machine_mode mode, unsigned int regno)
gcc_assert ((vec_flags & VEC_STRUCT) || end_regno == regno + 1);
for (; regno < end_regno; regno++)
{
+ /* Force the mode of SVE saves and restores even for single registers.
+ This is necessary because big-endian targets only allow LDR Z and
+ STR Z to be used with byte modes. */
machine_mode submode = mode;
- if (vec_flags & VEC_STRUCT)
+ if (vec_flags & VEC_SVE_PRED)
+ submode = VNx16BImode;
+ else if (vec_flags & VEC_SVE_DATA)
+ submode = SVE_BYTE_MODE;
+ else if (vec_flags & VEC_STRUCT)
{
- if (vec_flags & VEC_SVE_PRED)
- submode = VNx16BImode;
- else if (vec_flags & VEC_SVE_DATA)
- submode = SVE_BYTE_MODE;
- else if (vec_flags & VEC_PARTIAL)
+ if (vec_flags & VEC_PARTIAL)
submode = V8QImode;
else
submode = V16QImode;