arm64: dts: qcom: apq8016: remove superfluous "input-enable"
Commit Message
Pin configuration property "input-enable" was used with the intention to
disable the output, but this is done by default by Linux drivers. Since
patch ("dt-bindings: pinctrl: qcom: tlmm should use output-disable, not
input-enable") the property is not accepted anymore.
Cc: Douglas Anderson <dianders@chromium.org>
Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
---
arch/arm64/boot/dts/qcom/apq8016-sbc.dts | 2 --
1 file changed, 2 deletions(-)
Comments
On Fri, 7 Apr 2023 20:00:45 +0200, Krzysztof Kozlowski wrote:
> Pin configuration property "input-enable" was used with the intention to
> disable the output, but this is done by default by Linux drivers. Since
> patch ("dt-bindings: pinctrl: qcom: tlmm should use output-disable, not
> input-enable") the property is not accepted anymore.
>
>
Applied, thanks!
[1/1] arm64: dts: qcom: apq8016: remove superfluous "input-enable"
commit: 8624e6063cb15cc7ceeee6d54fc1761ab3d0baf7
Best regards,
@@ -729,7 +729,6 @@ usb_id_default: usb-id-default-state {
function = "gpio";
drive-strength = <8>;
- input-enable;
bias-pull-up;
};
@@ -770,7 +769,6 @@ msm_key_volp_n_default: msm-key-volp-n-default-state {
function = "gpio";
drive-strength = <8>;
- input-enable;
bias-pull-up;
};
};