The common Qualcomm TLMM pin controller schema for pin mux and config
already brings requirement of function for gpio pins and the definition
of drive-strength.
Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
Acked-by: Rob Herring <robh@kernel.org>
---
Changes since v2:
1. Drop drive-strength, reword commit msg.
2. Add tags.
3. This was previously part of:
https://lore.kernel.org/linux-arm-msm/20221011172358.69043-1-krzysztof.kozlowski@linaro.org/T/#m277d25a5f3e9d10ca8221a7fba62ca468a67a60b
---
.../bindings/pinctrl/qcom,sc7280-pinctrl.yaml | 18 ++----------------
1 file changed, 2 insertions(+), 16 deletions(-)
On Sun, 16 Oct 2022 13:22:12 -0400, Krzysztof Kozlowski wrote:
> The common Qualcomm TLMM pin controller schema for pin mux and config
> already brings requirement of function for gpio pins and the definition
> of drive-strength.
>
>
Applied, thanks!
[17/17] dt-bindings: pinctrl: qcom,sc7280: use common TLMM pin schema
https://git.kernel.org/krzk/linux-dt/c/b4997c1cb7d4c3900aab6fe5dad521f59369f93d
Best regards,
@@ -62,6 +62,7 @@ $defs:
description:
Pinctrl node's client devices use subnodes for desired pin configuration.
Client device subnodes use below standard properties.
+ $ref: qcom,tlmm-common.yaml#/$defs/qcom-tlmm-state
properties:
pins:
@@ -110,16 +111,11 @@ $defs:
uim1_clk, uim1_data, uim1_present, uim1_reset, usb2phy_ac,
usb_phy, vfr_0, vfr_1, vsense_trigger ]
- drive-strength:
- enum: [2, 4, 6, 8, 10, 12, 14, 16]
- default: 2
- description:
- Selects the drive strength for the specified pins, in mA.
-
bias-pull-down: true
bias-pull-up: true
bias-bus-hold: true
bias-disable: true
+ drive-strength: true
input-enable: true
output-high: true
output-low: true
@@ -127,16 +123,6 @@ $defs:
required:
- pins
- allOf:
- - $ref: /schemas/pinctrl/pincfg-node.yaml
- - if:
- properties:
- pins:
- pattern: "^gpio([0-9]|[1-9][0-9]|1[0-6][0-9]|17[0-4])$"
- then:
- required:
- - function
-
additionalProperties: false
allOf: