[v2,3/3] bus: ti-sysc: Configure uart quirks for k3 SoC
Commit Message
Enable the uart quirks similar to the earlier SoCs. Let's assume we are
likely going to need a k3 specific quirk mask separate from the earlier
SoCs, so let's not start changing the revision register mask at this point.
Note that SYSC_QUIRK_LEGACY_IDLE will be needed until we can remove the
need for pm_runtime_irq_safe() from 8250_omap driver.
Signed-off-by: Tony Lindgren <tony@atomide.com>
---
drivers/bus/ti-sysc.c | 2 ++
1 file changed, 2 insertions(+)
Comments
On 12:27-20230809, Tony Lindgren wrote:
> Enable the uart quirks similar to the earlier SoCs. Let's assume we are
> likely going to need a k3 specific quirk mask separate from the earlier
> SoCs, so let's not start changing the revision register mask at this point.
>
> Note that SYSC_QUIRK_LEGACY_IDLE will be needed until we can remove the
> need for pm_runtime_irq_safe() from 8250_omap driver.
>
> Signed-off-by: Tony Lindgren <tony@atomide.com>
> ---
> drivers/bus/ti-sysc.c | 2 ++
> 1 file changed, 2 insertions(+)
>
> diff --git a/drivers/bus/ti-sysc.c b/drivers/bus/ti-sysc.c
> --- a/drivers/bus/ti-sysc.c
> +++ b/drivers/bus/ti-sysc.c
> @@ -1525,6 +1525,8 @@ static const struct sysc_revision_quirk sysc_revision_quirks[] = {
> SYSC_QUIRK_SWSUP_SIDLE | SYSC_QUIRK_LEGACY_IDLE),
> SYSC_QUIRK("uart", 0, 0x50, 0x54, 0x58, 0x47422e03, 0xffffffff,
> SYSC_QUIRK_SWSUP_SIDLE | SYSC_QUIRK_LEGACY_IDLE),
> + SYSC_QUIRK("uart", 0, 0x50, 0x54, 0x58, 0x47424e03, 0xffffffff,
> + SYSC_QUIRK_SWSUP_SIDLE | SYSC_QUIRK_LEGACY_IDLE),
>
> /* Quirks that need to be set based on the module address */
> SYSC_QUIRK("mcpdm", 0x40132000, 0, 0x10, -ENODEV, 0x50000800, 0xffffffff,
> --
> 2.41.0
Reviewed-by: Nishanth Menon <nm@ti.com>
@@ -1525,6 +1525,8 @@ static const struct sysc_revision_quirk sysc_revision_quirks[] = {
SYSC_QUIRK_SWSUP_SIDLE | SYSC_QUIRK_LEGACY_IDLE),
SYSC_QUIRK("uart", 0, 0x50, 0x54, 0x58, 0x47422e03, 0xffffffff,
SYSC_QUIRK_SWSUP_SIDLE | SYSC_QUIRK_LEGACY_IDLE),
+ SYSC_QUIRK("uart", 0, 0x50, 0x54, 0x58, 0x47424e03, 0xffffffff,
+ SYSC_QUIRK_SWSUP_SIDLE | SYSC_QUIRK_LEGACY_IDLE),
/* Quirks that need to be set based on the module address */
SYSC_QUIRK("mcpdm", 0x40132000, 0, 0x10, -ENODEV, 0x50000800, 0xffffffff,