[v2,4/4] spi: rzv2m-csi: Make use of device_set_node
Commit Message
Use device_set_node instead of assigning controller->dev.of_node
directly because it also sets the firmware node.
Signed-off-by: Fabrizio Castro <fabrizio.castro.jz@renesas.com>
Suggested-by: Andy Shevchenko <andy.shevchenko@gmail.com>
Reviewed-by: Andy Shevchenko <andy.shevchenko@gmail.com>
---
v2: Edited the changelog and added include of property.h, according
to the feedback received from Andy.
drivers/spi/spi-rzv2m-csi.c | 4 +++-
1 file changed, 3 insertions(+), 1 deletion(-)
Comments
On Tue, Jul 18, 2023 at 10:25 PM Fabrizio Castro
<fabrizio.castro.jz@renesas.com> wrote:
>
> Use device_set_node instead of assigning controller->dev.of_node
device_set_node()
> directly because it also sets the firmware node.
@@ -12,6 +12,7 @@
#include <linux/iopoll.h>
#include <linux/log2.h>
#include <linux/platform_device.h>
+#include <linux/property.h>
#include <linux/reset.h>
#include <linux/spi/spi.h>
#include <linux/units.h>
@@ -589,12 +590,13 @@ static int rzv2m_csi_probe(struct platform_device *pdev)
init_waitqueue_head(&csi->wait);
controller->mode_bits = SPI_CPOL | SPI_CPHA | SPI_LSB_FIRST;
- controller->dev.of_node = pdev->dev.of_node;
controller->bits_per_word_mask = SPI_BPW_MASK(16) | SPI_BPW_MASK(8);
controller->setup = rzv2m_csi_setup;
controller->transfer_one = rzv2m_csi_transfer_one;
controller->use_gpio_descriptors = true;
+ device_set_node(&controller->dev, dev_fwnode(dev));
+
ret = devm_request_irq(dev, irq, rzv2m_csi_irq_handler, 0,
dev_name(dev), csi);
if (ret)